<– Day 1: July 21, Alaska Or Rust Has Begun | Day 3: July 23,  Alaska Updates  –>

UPDATE: To clarify this post, I’d been spending several weeks getting Patterson ready for the trip. Like everyone else, I had to deal with last minute issues, like my front hubs getting too warm. Here’s my efforts to pull our 1956 DJ-3A from Seattle to Pasco, Washington, where we would officially start our leg of the trip with Brazilians Hugo and Fernando Vidal.

Original Post July 22, 2017: Well, folks, we are one step closer to Alaska; I successfully pulled Patterson over to Pasco yesterday. Normally, the drive takes just over three hours. However, I took the scenic, slow route, with some stops along the way to adjust my front wheel bearings. Apparently, I tightened them too tight (I thought I had left some play, but I guess not enough). I suspected this when I finished installing them on Friday, which is why I made a decision to bring along my hub puller.

About 10 minutes into my journey I pulled over and felt both front hubs. They didn’t feel hot. Then, I got stuck in stop-and-go traffic for about an hour heading eastbound on I90 (for those that know the area … from Tiger Mountain on Highway 18 all the way to the first big curve on I90 east of North Bend).

Traffic was awful!

I climbed the pass on Interstate 90, then pulled off at Snoqualmie and felt the hubs. They were hot to the touch. So, I loosened the bolts, let them cool, and had some delicious BBQ at Webbs. We’ve eaten there twice and everything that we’ve tried — pulled pork, brisket, sausage, potatoes, coleslaw and corner bread — have been excellent and surprisingly affordable!

There are worse places to hangout and eat.

Everything was delicious!

The hubs were still feeling hot by the time I reached Indian John Hill east of Cle Elum. So, I readjusted them again. About that time, a father and his sons walked up and asked about the jeep, so I had them sign the right fender.

After Ellensburg, I took the Ellensburg-Selah Canyon Road (not sure what the name is offhand) and stopped to feel the hubs again. Loosening the bolt wasn’t working, so I retrieved my tools and worked on the driver’s hub.

Nice evening and view for working on the hubs. This passenger side hub was particularly difficult.

It wasn’t easy, but I finally got one stubborn hub to give. The second hub (passenger side) was more difficult and, after breaking an older torque wrench (it was already in bad shape) I decided to leave the nut a little loose AND try some rougher back roads. It took several hours at 30-40 mph, but finally the bearing was pushed out a little. After that, I was able to up my speed to 60 mph without any heat buildup.

I made it back to Pasco about midnight feeling victorious!

<– Day 1: July 21, Alaska Or Rust Has Begun | Day 3: July 23,  Alaska Updates  –>