UPDATE: **SOLD** Was $12,500.
This could be fun on the salt flats.
“Custom build rat rod, 4″ chop and channeled. Fresh 283 sbc and 700r4 trans. Ford 9 inch. Custom Zd frame. Everything works. Runs. Ready to go.”
UPDATE: **SOLD** Was $12,500.
This could be fun on the salt flats.
“Custom build rat rod, 4″ chop and channeled. Fresh 283 sbc and 700r4 trans. Ford 9 inch. Custom Zd frame. Everything works. Runs. Ready to go.”
Appears to have a replacement body.
“Cj3b Body is in good condition and has a small rust spots on driver side of the body nothing major floor boards in good condition it’s been sitting up for about three years fuel system will need to be cleaned an needs some tires Jeep is complete an will run also has small warn winch on front I have clean title in hand $2000.00 or best offer I will not trade cash only I will not hold this for you so don’t ask .”
UPDATE: **SOLD** Was $2800.
(01/22/2018) Ted’s got this trencher for sale.
“For sale late sixties CJ5 Auburn Jeep A Trench 1968? Would make a great yard truck/ Plow Jeep,comes with dirt plow and snow plow. Starts, runs good and drives , clutch feels good , no brakes . Body’s kinda rough but frame looks pretty good . Havent had a chance to go over it well to check everything but seems to be pretty complete , missing one of the augers. PTO engages and shaft spins . Not very familiar with these units so will try my best to answer any questions. Looks complete enough to restore or get going and use as is, or would be a great parts donor for another Auburn Trencher unit. Front counter weight there ,as is the creeper gear , pto assembly, Fhead motor, overload springs ( Canfields or Koenigs ?) etc Too many Jeeps to work on this one needs a new home $2800 Feel free to call,text, or email for details , I will try my best to answer all questions. If I miss your call (very loud at work) I will return the call”
Project.
“1942 war 2 MB Willys (jeep) for Restoration or Parts. Partially disassembled. Witch means I have removed the mud and some rust.
Ford flat head, 3 speed trans
The tub has been sand blasted and I have new panels for the bad spots. To many projects and something has to”
https://portland.craigslist.org/clk/cto/d/1942-mb-willys-needs/6486031605.html
Needs work.
“Great project Jeep for someone. CLEAN TITLE Starts right up, runs and drives. Will need some work to be road worthy. Needs some wiring (chassis wiring) Needs brake work. (Master cylinder) One tire leaks down after a few days, will need new tube. Had some oil leaks that should be fixed before it is driven much. Currently has no seats but I’m working on getting some mounted. Motor is a Studebaker Flathead I6 170 from a early 50’s champion or similar The rest of the drivetrain is all original Willy’s. Chassis is rust free but the body has some rust. Will be a fun project for someone. Won’t take much to get it on the road.”
UPDATE: This has parts for a couple different trucks.
Might need some interior finishing.
“1947 Willys Jeep Pick-up Truck 250 ci. in. Chevy engine Complete rebuilt transmission – transfer case Warn brand over drive addition, Power Steering allnew brake parts also comes with pioneer rack with shovel and tire pump. This Jeep was taken fully apart and put back together all new parts. Will need interior (headliner, carpet) Drives,stops,shifts,is registered in my name with a clear Florida title and insured.”
https://orlando.craigslist.org/cto/d/1947-willys-jeep-pick-up-with/6482951860.html
UPDATE: **SOLD** Was $3500.
It’s a column shift with indents (top indent at least) so likely a VEC CJ-2A. Body is rough, though has been patched in places. You don’t often see just one part time hub. I’d check to make sure the left front axle and/or front R&P doesn’t have some issue.
“I was told by the heirs that this was a 1948 Willys Jeep, I do not have a title, so I am unsure , there is a long number on the engine, that could lend a clue. This is a 3 speed standard trans, on the column, with two shift levers on the floor, it rolls easy, and the linkage is all free to the trans and transfer case. The odometer reads 38k miles, what you see is what I have, there are no extra parts, engine is complete, radiator and all parts in engine compartment intact.
Serious only, I’m sure the parts are hard to find for this vintage , possibly a 1947 Willys Jeep, Convertible,
the frame is good, rears are complete, and has locking hub on the front left wheel , under the paint is was a medium green when new.”
UPDATE: **SOLD** Was No Price.
The body might be MB, given the gas tank. No full floaters in the back. Probably a mix of parts.
“Got it on trade don’t know much about it but it ain’t locked up willing to sell or trade for other vehicles it is a good project for someone who has the time trade for truck or just let me know what you got”
UPDATE: **SOLD**
These two were part of a collection for sale in late 2017.
1. CJ-2A $1000: I have a Willys Jeep, flat hood, flat 4 cylinder, mostly complete. NO title but can give bill of sale. $1,000 cash or May trade for something.
2.1960 CJ-3B $1500: “I have a 1960 Willys Jeep. Tall hood which means the inline 4 cylinder. Complete I believe but rough. Clear KY title. Please no calls or texts after 11pm. May trade for something but prefer cash or cash and bang.”
UPDATE: **SOLD** Was $5000.
Has a variety of updates, but still very much a project.
“This is a project Jeep. 327chevy, sm420 transmission, custom frame complete body. Lots of parts included too much to list. Just don’t have time to finish.”
Everyone once in a while readers have forwarded Facebook Marketplace ads with a jeep for sale. But, for the most part I have ignored this resource. I just didn’t think there was much there. I was wrong.
There are a large number of vintage jeeps for sale that I haven’t seen listed elsewhere. I’ve listed a number of them in posts for today. However, I know not everyone has a FB account, so that doesn’t create a dilemma for some folks. I don’t have an answer of that just yet. I also don’t have a system yet for efficiently searching the Marketplace on a national basis, so I don’t know how using the Marketplace will effect my time.
To see what is possible, I plan to do research into the Marketplace platform. It would be great if I could automate some of this stuff, making less work for me and more jeeps for readers. We’ll see how it goes!
Seth shared this unusual opportunity. This Spring a group is crossing Greenland. The event is auctioning off a seat. The price starts at a meager $25k. Learn more on eBay
This look like a nice build.
“1958 Willy’s CJ-3B high hood, $15,000 or best offer. Throttle bottle fuel injected 350 with gear drive, T18 4 Speed coupled to Dana 20 transfer case, Dana 44 front and rear axles, warn 30 spline axle shafts, full floating rear end, Detroit locker in the front and ARB air locker in the rear, 488 gears. 33X12.5X15 BFG mud terrain tires, 5×5.5 bolt pattern, spare tire and carrier, on board air, disc brakes all the way around, hydraulic clutch, Black Diamond XCL coil link suspension, Warn 9500 winch, new deep cycle optima, new fuel pumps. This is your chance to own a piece of NW four wheeling history and climb just about any trail, unfortunately it just sits most of the time and needs a new home where it can be driven, rock crawled, wheeled, pampered and appreciated. If you have ever opened a 4×4 magazine from the early to mid 90’s odds are you saw this in there.”
Looks in good shape. Has some updates.
“1950 CJ-3A in great condition. All original jeep minus the Buick V-6 and 12-V electrical system. The Buick 198 engine has been recently tuned and runs great. Fun to cruise around in. 3 speed T-90 and Spicer transfer case. 5.38:1 original gearing. New clutch, new brake master cylinder, new tires, Superwinch locking front hubs, newer black Bestop soft top. Same owners since early 70’s.”
Seller also has an early VEC CJ-2A for sale.
“This is a rare World War Two military jeep Willys MB. It runs and drives but for dependable driving will need more attention. The Jeep came from Page Arizona and was registered with an Arizona ID with oversight of 1951 as the year, quite common mistake made at DMV in old days.. It is 100% genuine MB Jeep from pre-1945. The body is solid without any bondo and needs to be gone through before going to the paint shop. What you see in the pics is surface rust being exposed to the weather in Page Arizona where it came from. Chassis and undercarriage are solid with just the typical rust in the channels. Inner Windshield frame has rust but outer frame is solid. Great candidate for show quality restoration . The previous owner overhauled the original flat head MB “devil” engine and installed rebuilt tranny and transfer case done by a professional vintage jeep part supplier here in Phoenix. Carter Carburetor still needs fine tuning and electrical harness replaced. Vehicle runs and drives but needs restoration to be reliable driver or showing in parades. I can send you multiple photos and answer any questions you may have if seriously interested in owning a piece of war memorabilia that will only appreciate with time .
I also have a very early production 1946 CJ2A VEJ. Might sell together to any serious buyer.”
UPDATE: **SOLD** Was $3000.
Looks like a good foundation for a racer.
“Would love to see someone use this instead of have it rot in my garage! CHASSIS ONLY, no motor, no wheels and tires Rebuilt 4spd toploader with t176 Gary Marshall shifter on top ( 1 season of use) Rebuilt Dana 20 ( 1 season old, rebuilt by billy Bob’s) Fox 2.0 shocks on all corners New drivelines Beard seats Crow harness’”
UPDATE: **SOLD** Was $12,999.
Bill spotted this one.
“Less that 50,00 Original Miles! Jeep FC 170 4×4 Super Rare!
Needs some love but has always been taken care of. 3 owners to the best of my knowledge. Runs great, original motor. Very small leak from the pan, only needs a new pan gasket. No rust holes or any significant rust for that matter. Original paint as well, however could use a new paint job.
1 dent behind the driver door can see in pic would be an easy fix. Ready for restoration or even just a fun truck to cruise around. Again these things are pretty hard to find in good shape let alone running. With less than 50,000 original miles its a gem!
Serious buyers only!!”
UPDATE: **SOLD** was $7500.
Looks like a good parade jeep.
“eep runs and drives and is great for running to the store or driving in a parade. It has new brakes and starts every time. The jeep has working blinkers, seat belts, brake lights, headlights, and a horn. It is street legal and has a clean Kansas title.
Solid body without any active rust areas to speak off. 4×4 works. Gauges work. Tires hold air. Black vinyl seats are very comfortable with springs.
The transmission DOES grind when shifting from third to second about half the time. Sometimes it doesn’t and others times it does. The jeep still drives fine. Forums say the synchronizers need replaced, but not sure.
It does have oil leaks that I heard are normal on these jeeps.
Fun jeep at a reasonable price to still do repairs if you choose, or just drive it as is. Get ready for Spring parades!”
It has no title.
“1946 Willys runs and drives, no title.”
UPDATE: **SOLD** Was $3500.
Unclear if runs or not.
“1952 Willy’s Jeep M38A1. Went into fire service after it’s military service. Great Jeep for restorations. Call or text John. Contact info in last picture. Be sure to tell him Jamison sent you. No calls after 10pm central.”
Look solid. Has some updates.
“We love this little Jeep but need the garage space!”
UPDATE: **SOLD** Was $6000.
Runs, but needs brakes.
“Cab over 1959 fc170 Runs drives great No brakes master cylinder needs rebuilt have kit 226 hurricane six cylinder T90 three speed 4×4 hi low range $6000 cash”
Assembly required.
“1944 Ford GPW project jeep. It came from long term dry storage. It has a decent solid body and straight frame. It’s not perfect, but it’s an easy one for restoration or use as is.
Comes with a pair of GPW axle housings and the other parts shown in the photo’s..
Nothing else comes with the Jeep. Just what you see in the photo’s. No motor, no trans, etc…
If you have a rusty running jeep this could save you some time, effort, money.
I have the title
I DO NOT want to trade.
You load, you haul..bring help… It will all fit in a full size truck bed if you don’t have a trailer.
Please email your NAME and TEXT phone number. Or I will NOT reply to you.”
https://seattle.craigslist.org/est/cto/d/1944-ford-gpw-project-ww2-jeep/6482870671.html
Not sure how much value is here.
“Does not run 😉 its a project needs every system gone thru. Civilian model I do have the title could be made legally roadworthy it is very complete but needs restored may consider trades don’t waste my time I won’t waste your”
Seller listed a price of $1000, but I suspect that’s just a holding price.
“As is parts or projects”