Mike shared this video of Davin and Jeff working to revive this 1966 CJ-5 with a Meyer Cab. Made in Canada, the serial number places the production of this jeep at the end of December.
Ogelsby Jeep on eBay
The buy-it-now price is $50 and shipping is only $15. The gold appears to be added over the original red. But, looks like a fine buy.
View all the information on eBay
“This is a oglesby jeep selling as is do not know any thing about them cast aluminum”
1951 CJ-3A Hemlock, MI $9900
This appears to includes a rear PTO plus gearbox and drum pulley.
https://www.facebook.com/groups/WillysSwapMeet/posts/3512898582316729/
“1951 Willy’s Ag. Jeep”
1961 CJ-5 Van Nuys, CA $8500
Lots of stock jeep here. This has a Koenig hardtop and a set of early Husky hubs.
https://www.facebook.com/marketplace/item/642826257786806
“1961 CJ5 100% original CA barn find survivor. Aftermarket factory installed hard top has never been removed. All windows and glass good and functioning. Everything works. Owner told me the Jeep had a re-spray in the 70’s but you can’t tell because it’s faded and the patina. Paint will shine with a buff and wax but I don’t like my cars like that. Took this in on partial trade as part of my collection but do not need it. It came with a Jeepster and some other parts I needed. Unmolested and uncut. No modifications. Original factory installed side steps. Drive as is or lift it. Head turner everywhere I park it. Brand new industrial battery. Brand new tires. Dropping off Monday (7/10) at carburetor shop to rebuild it, so it runs perfect. It has a little dead spot that I don’t like. No leaks. Engine bay is perfect. Zero rust. Original rubber floor mat. Push button starter. 4WD, locking hubs and transfer case all working. 12 volt vintage glass dome light installed but nothing cut or drill”
1947 CJ-2A Sulphur, OK $14,000
This may have a replacement body. Either way, it looks solid.
https://www.facebook.com/groups/842398679463287/permalink/1941634712873006/
“1947 Willys Jeep. 350 Chevy
4 speed granny Detroit lockers
High performance
New tires new battery
Manual transmission
28,000 miles
To much to list”
1957 FC-170 Onalaska, WA $3000
UPDATE: Price dropped to $3000
(10/08/2021) Blaine spotted this marriage between an FC-170 and a Corvette chassis. It appears there’s plenty of work left.
https://www.facebook.com/marketplace/item/884877239405039
“1957 fc150 on modified 1981 corvette frame. Little to no rust, most metal work done. Have new windshield and rear glass. Doors repaired new floor pan. No engine or trans. Have stock dash.All reasonable offers considered. Willing consider to trade for farm quad +cash”
1967 CJ-6 Perkins Diesel Windsor, PA $11,500
Matt shared this rare Perkins diesel. It has the correct serial number plate for a diesel, too. It does have rust.
https://www.facebook.com/marketplace/item/149327051514207
“1967 Jeep CJ-6 with Perkins diesel engine. All original and minimal rust compared to most CJ’s of this vintage. Very rare Perkins diesel engine runs but will need rebuild. It will run but smokes excessively and is low on power. Injection pump and injectors have been rebuilt. Production numbers suggest that less than 600 CJ-6’s were built with the Perkins engine. The body and floors have rust in all of the typical locations but is not a total rust bucket. Please be familiar with the rarity of this Jeep before you criticize the asking price. Clear Pennsylvania title included. All low ball offers will be ignored.”
Dana 41 Axle Leavenworth, KS $300
Jeff is selling this axle. Hopefully someone can use it.
https://www.facebook.com/marketplace/item/1120976382192663
“Dana 41 axle for 1947 CJ2A, 10-spline with tapered shaft. This is a Dana 41 axle for a CJ2A Jeep. The housing and axle tubes are in excellent condition. It has a relatively new ring and pinion along with pinion bearing and seal. The axle shafts are 10-spline with tapered ends for the hubs. I put new bearings on the shafts,but slots for the long woodruff key that holds the hub on is gouged out and would need repaired or replaced. Includes an extra long-side axle drive shaft that mate”
3 CJ-2As, 2 CJ-5s, M-38 + Parts Glennville, GA $13,000
UPDATE: Price dropped to $13,000.
(06/272023) Seller wants to sell as a lot. Only the 3 2as and 1 CJ-5 are pictured (unless the pics confused me).
https://www.facebook.com/marketplace/item/653132376302885/
“Selling all my jeep stuff at one time,
49 CJ2A with title running driving stopping lots of new parts
Two 47 CJ2As one runs will shift 1st and reverse the other is complete drivetrain parts jeep
Two CJ5s one 1960s runs drives, other complete drivetrain parts jeep believe 55
M38 with new aftermarket tub in the middle of a frame off with a bunch of GPW stuff
2 engines already been through machine shop, 2 extra M38 tubs one maybe salvageable other parts, extra M38 frame, extra CJ frame
And a bunch of other parts, too many to list”
1946 CJ-2A Nebraska $3600
This has some updates, including a different sort of carb and exhaust setup. The top is from Porter & Reed.
https://www.facebook.com/groups/247270289549336/permalink/1331042294505458/
“1946 willys Jeep 2.8 GM V6 $3,600 located in northeast Nebraska”