UPDATE:  Status unknown.  Price was $1700.

It’s a project.

“This is a project that I just can’t seem to finish. No more motivation, interest shifting back to old Camaros.
Here’s what it has:

New frame made from 2×3 and 2×4 box steel, stretched 8 inches (original frame comes with it)
Tub, stretched 8 inches in the cab, no tailgate
Stock flat fenders, grille and hood
Windshield frame with good glass (glass is out) and wiper motors (unknown if they are operable)
YJ springs, spring over configuration
New shackles, spring mounts and spring bushings
Dana 44 rear axle with 5.38 gears (stock)
Narrowed Dana 44 front housing from 75 Dodge, with outers from 85 Power Wagon and new rotors (no axle shafts, unknown R&P)
New Cragar black 8 hole 15×10 rims
New Dunlop Mud Rover 35×12.50r15 tires (rolled in and out of the garage a few times)
76 Chevy tilt steering column with new GT steering wheel
Two high back bucket seats
Buick 231 engine (disassembled, unknown condition, was going to have it rebuilt) with a Holley and Edelbrock aluminum manifold
Ford T18 tranny (unknown condition)
Dana 18 T-case (disassembled, unknown condition)
Has VIN plate and clear title, currently non-op status

With the stretch and the springs mounted to the bumpers, wheelbase is 96″”

UPDATE: **SOLD** Was $1800

(12/26/2012) There’s some value here.

“1946 willys cj2a, mostly complete. Has homemade top. engine locked up. all drivetrain is intact. the trans and transfer case are not locked up. I was going to use it as a parts vehicle for the 47. 1947 willys cj2a. runs and drives however I now have the body off to paint do any repairs needed. Floors have been replaced on the 47. many new parts included, ie…..new master cylinder, wiring harness, back seat, ect. Jeep is apart and needs to be reassembled but all bolts are in bags and marked. Extra windshield frame is also included. This jeep has been converted to 12 volt by previous owner. Everything I have for this willys go with it. Email for extra photos. $1800.00 OBO. Both for one money. Will not seperate, having just one does me no good.”

UPDATE: **SOLD** Was $1000

(01/03/2012) I’m wondering if this is a fiberglas body?  The driver’s seat and steering has been moved to the middle.

“1949 Willys Jeep no title. Dana 60s axles, this is a project that needs just a little work to be finished, has transfer case and turbo 350 transmission, will include running big block 454. Started as a project don’t have the room and wife says it has to go.”

UPDATE: *S*OLD** Was $4800.

Those rear rollbar angles have the strangest waves.

“1952 Willys “Farm Jeep” CJ3-A for sale. Mostly original vehicle. 4 cylinder, runs good, lock-out hubs, four wheel drive, hi/lo all work good. 6 volt electrical system, snow plow, new seats. Good PA title, vehicle not inspected. I use it around farm for towing, hauling, plowing snow. This is one of the most sought-after Willys civilian Jeep models, would make a great candidate for restoration project, or just have fun with it as is.”

UPDATE: **SOLD** Was $3000.

(09/11/2011) “This is a great little jeep!!! It runs on a 4cyl motor and the original transmission. the jeep is lifted with 35″ mickey thompson baja claw tires. It was painted last year and installed new glass… This jeep is a lot of fun in the hills or out in the lava beds.”

UPDATE:  Still Available

(01/16/2012) This looks like a nice runabout jeep.  It might make a good project.

“Willys CJ2A Jeep 1946
2300 Ford Motor with electronic ignition
Factory rebuilt Holly carb and new fuel pump
Fuel tank cleaned and sealed
4 speed transmission with high range low range in 2WD or 4WD plus over drive
Tilt steering column from 1984 Camaro
Saginaw steering box for easy turns
Honda Accord seats

Call Mike at 253-232-2085
or leave message at 253-851-7696”

http://seattle.craigslist.org/kit/cto/3637943714.html