UPDATE: Price dropped to $13,500.

This looks solid; it has some minor mods.

https://www.facebook.com/marketplace/item/1061402431414520

“this is a 1953 willy jeep it has 32,000 original miles. runs and drives smooth. 3 speed everything works on it.”

Peter shared this project.

https://www.facebook.com/marketplace/item/583980526793078/

“1947 Willys CJ2A 4×4 V8 NO PINK SLIP •⚠️BILL OF SALE⚠️• •I have all 3 Vin Tags •265 V8 Small Block out of a 1955 Bel Air. •The engine is seized and way out dated. •There are no cables or wires on this vehicle, meaning it does not run, start, drive, you name it. Currently for the flint stones. • Transmission and Transfer case are original to the vehicle. •Only thing not original is engine and some metal used to patch rust. •Gas tank has a small hole so it will need to be welded or replaced •Mileage is unknown on this vehicle •It did once run with the V8 in it. •All bushing and rubber seals have cracking. • Vehicle rolls and turns freely. Steering is hooked up •All tires hood air but do not recommend pulling vehicle at high speeds. • Extra parts include, radiator, ignition, starter, fuel pump, brake pedal, clutch pedal, wind shield wiper motor, high beam floor switch, fan, tow hook and shifter cover. •Rear floor pan is out of a YJ Jeep.”

Only the one pic provided. It looks like the driver’s rear wheel-well has been modified.

https://www.facebook.com/marketplace/item/376033394615956/

“1953 turns over but won’t start clean title needs restored project that’s it bill of sale the jeep needs front seats has back one it’s off of dmv but can be Registered my mechanic told me was the timing but sold as is you need a trailer or tow truck”

UPDATE: **Sold**

This is a REALLY well done build. The customizations are clean and simply executed. David has a clear title, but the serial number appears to be from the previous L-head engine (not uncommon).

The only issue with the jeep is that the hazards are staying on when the jeep is running. The switch to turn them off isn’t obvious (unclear where that is).

Here are the specs as best as I could determine:

It is a CJ-3A based on the body and the frame
Buick V6 (most likely a 225)
12 volt system
3 Speed (T-14?)
Dana 20 transfercase (single lever)
Custom radiator
Power Steering
Tilt Steering wheel (possibly out of a Cherokee jeep?)
Dana 30 front (most likely)
Dana 44 rear 30 spline axle center pumpkin
Dual tanks with a change-over valve
Swing pedals
Mechanical, but custom, clutch setup.
Dual master brake cylinder
Disc brakes in the front
Drum brakes in the rear (likely 11″)
Full Roll cage, though mounted to the body and not to the frame
Soft top
Serial number likely based on the previous L-head 4 cyl engine
Custom rear bumper

Continue reading →

Looks like a good price.

https://seattle.craigslist.org/sno/cto/d/mountlake-terrace-1950-willys-cj3a-jeep/7512991843.html

“1950 CJ-3A. Affordable project jeep. Original drivetrain. 11” brake upgrade. New springs shackles and hangers. Exhaust and shocks also replaced. Fold away spare tire mount. Tow bar. Extra military wheel set.
Contact me with serious questions. Clear title in my name. Not taking offers. Price is firm.”

This has an unusual windshield setup.

https://killeen.craigslist.org/atq/d/harker-heights-willys-cj-2a/7512395189.html

“CJ-2A with some extras. Not fully stock but the original engine and powertrain. Recently rebuilt transmission and transfer case. Plenty of recent maintenance has been done to include front brakes, carburetor, fuel lines…etc”

This includes a rear PTO, gearbox and shield.

https://sanantonio.craigslist.org/cto/d/bulverde-1949-jeep-willys-cj-3a/7510917025.html

“1949 Jeep Willys CJ3A. Power PTO on rear end, factory bed extender, all original. We are only the third owner. Runs great and in excellent condition.”

This has a few mods, including an f-head.

https://austin.craigslist.org/cto/d/cedar-creek-1947-jeep-cj2-cj3b-engine/7507183136.html

“1947 Jeep CJ2 with a CJ3B engine (so its not the flat head engine)
Runs excellent. Brand new gas tank installed. New seat upholstery needs installed. Has new bimini top. Comes with an extra transmission and transfer case.
Clutch cable does need some adjustment. I did drive this down the road a few weeks ago, ran, drove, and shifted fine.
4×4 works.
Has tow hitch on front.
Clean title in hand.
$3500 or trade for other classic cars or trucks.”

Given the ignition switch holes aren’t in the dash, this might have a 3A body.

https://albuquerque.craigslist.org/cto/d/isleta-willys-jeep/7502882759.html

“1948 willys, this is a project vehicle, all original parts are there,engine turns, no title!!!”

It sounds like this may need some TLC.

https://dallas.craigslist.org/ndf/cto/d/nevada-1946-willys-jeep-trades/7503635831.html

“The motor has been changed with a 2.4 liter from a Ford Pinto. This has a Warn overdrive. The body is in nice shape. The carb needs some adjustment. It has 2 sets of tires that includes the original rims. Both set need replacing. Has the soft top and doors that are in fair condition.”