It runs and plows.

http://centralmich.craigslist.org/cto/4780126992.html

“This is a 1963 Willys Jeep CJ-5 that has a working hydraulic plow. The engine is a 225 Buick V6 engine that came out of a 1970 Jeep CJ-5. It has the original transmission and transfer case with the 3 speed and reverse. The engine does run a little rough and backfires on the drivers bank. I put new spark plugs, cap and rotor, wires, coil, and condenser on it and it smoothed out some but not all. I have only used it last winter and it worked great. I replaced all brake components including the master cylinder, all 4 wheel cylinders, and brake lines. It has brand new 4×4 lockout hubs on the front. The headlights on the jeep as well as the ones on the plow work.

It has the original drivers seat in it and I also have the original passenger seat that will be included if the purchaser wants it. It runs off a small plastic gas can. I have the original that was mounted under the drivers seat again, if the purchaser wants it. The plow looks 5-5 1/2 feet wide (I have not measured it). The front tires are the stock skinny size, the rears are wider (not sure what size) but all have good tread. I never got stuck with it and the 4×4 works great. The hydraulic pump for the plow does leak some. I’m not sure where but it is a very slow leak. The pump was manufactured in Grand Rapids Michigan. It has a homemade roof from steel bars, osb board and a couple 2×4’s. It will not come with a battery but I have one that can be used so you can hear it run and drive onto a trailer. It would be roadworthy if it had brake lights and turn signals that worked. “

No pics provided.

“dana 60 rear end, dana 40 front axle, automatic transmission, corvette LT1 fuel injected V8, 400hp 37″ tiers on 17″ rims. I have 30k into this project. in good running condition. have hard top and soft top and doors.”

http://orangecounty.craigslist.org/cto/4780274946.html