These two photos appeared in the June 1955 issue of Willys News.
1944 MB Charlottesville, VA **SOLD**
UPDATE: **SOLD** Was $14,000.
Not totally original, but looks like a solid parade jeep.
“This is a 1944 Willys MB that saw service in Europe from 1944 through 1945; was sold surplus following the war; current owner bought the jeep in Germany in 1987 and returned the jeep to Baltimore in 1989. Jeep is in perfect running condition, has no rust, and has original seats and canvas top; engine is not the original but is a 1945 original Willys engine. Original transmission, transfer case, and axles however. Has been converted to 12-volt and has a non-original electrical wiring harness. This jeep could be fully restored to show condition or used as-is. Given olive drab coat of paint with World War II markings in 2000.”
1947 CJ-2A Princeton, TX **SOLD**
UPDATE: **SOLD** Was $2750.
Runs, drives and plows.
“This is a 1947 jeep willys cj2a with original rebuilt motor rebuilt t-90 3 speed transmission and rebuilt transferase with PTO with working lever. Has a hydraulic plow that the pump is being driven with a shaft attached to main crank. Everything works great! Comes with tire chains for extra traction. Has been converted to 12v and will start in these freezing temps. Body is SOLID floors are extremely solid with zero rust on whole jeep. Frame has been blasted and repainted. New brakes in the front. Clean title”
1952 M-38 Jaconson, MN **SOLD**
UPDATE: **SOLD** Was $4000
It runs.
“1952 Military Jeep. Runs great. Have top and doors. Original 4 cylinder motor.”
1946 CJ-2A Bonham, TX **Status Unknown**
UPDATE: **Status Unknown** Was $3500.
Runs and drives.
“1946 Willys Jeep 4×4 . This is a running and driving Willys . Trans cable needs adjusting as it has some trouble going into gear but drives fine. Transfer case works great and has been mostly used as a farm and ranch get around truck. As you can see in the pics it has little rust but to my knowledge the body is original. Clean title in hand.”
1953 CJ-3A Vancleave, MS **SOLD**
UPDATE: **SOLD** Was Make Offer.
Has a fiberglass body.
“Im selling a 1953 willys jeep it has the original engine and trans. runs and drives good but it wouldnt hurt to adjust the clutch whitch i may do befor i sell it. it has a 1951 fiberglass body with brand new lowback seats. i have the original seat frames they need new cushions front and rear. i put a 15 gallon fuel tank in the back where the rear seat goes but i have the original that goes under the front seat that will go with it. you will notice from the pictures it has a small scoop on the hood to clear the engine. since the hood is shorter on a 1951. It also has a home made 2 1/2 inch lift on it that was on it when i got it. I will also trade for a side by side or 4 stroke jet ski both must be running. make an offer”
1952 M-38 Keyes, CA $2500
No pics provided.
“Great project that needs to be finished….$2,500 firm…cash only…phone calls only….original transmission and motor….call between 8am – 8pm nothing after 8pm”
Flattie on CJ-5 Chassis Winamac, IN **SOLD**
UPDATE; **SOLD** Was $750.
(11/30/2014) With the later model axles, this chassis might of interest to someone.
“my brother in law got this in a trade. It appears to be an old Willys body. On a CJ 5 frame. With a what I think is a Ford Motor could be AMC 4 cylinder did not look close. Frame is actually in good shape. Motor trans and transfer case are all there. I believe it has a Dana 30 front with disc brakes and a 20 in the rear. I do not know much about it. it is 90 miles north of north side of Indy.if you have any questions please feel free to text or call me. We do have a title for it. There is no front clip. What you see in the pictures is what he has.”
1948 CJ-2A Sonora, CA **SOLD**
UPDATE: **SOLD** Was $1800.
(10/30/2014) Project or parts jeep.
“1948 jeep willys CJ2A project with title,no tranny or t-case, what you see in the pictures is what you get.”
1946 CJ-2A Sonora, CA **SOLD**
UPDATE: **SOLD** Was $10,000
(10/30/2014) It appears to have a VEC body.
“1946 jeep willys CJ2A trail rig, fuel injected GM V6, SM420, and twin stick with PTO. narrowed 9″ (nine) inch ford rear axle and narrowed dana front axle, with lockers front and rear. on board air, warn winch and off-road lights. call or text ”
1948 Truck Fort Benton, MT **SOLD**
UPDATE: Was $4700. **SOLD**
“It’s got a 350 with high performance intake carb headers motor is awesome. Turbo 350 trans Brand new 35×12.50 r 15. Cab and interior in great shape. It runs and drives. It’s got a Ford 9inch rear axle. Drum brakes. Paint on the cab is in ok shape, the flat bed has good paint on it. With a little work it could be an awesome truck!(the transfer case 203 dosen’t shift to well. It gets squirmy around 50 mph the way the steering set up and the dash would need some work probably new gauges) and there’s few more things too but those are the main things wrong with it. The steering column and wiring harness are out of a 77 GM truck. CASH ONLY”
2014 Ice Racing Pics at Steve Nelson Photography
Photographer Steve Nelson is a sponsor of the Our Gang Ice Racing organization. He took a ton of photos during the 2014 season and is planning more for this season (as soon as the weather cooperates). Check out all his great 2014 pics here:
http://stevenelsonphotography.smugmug.com/Ice-Racing-2014-1/
Photo of Slat Grille MB on eBay
The seller of these photos knows jeeps pretty well to spot this as a slat grille.
“WWII PHOTO EARLY SLAT GRILL MB JEEP AND CCKW of the 4th F.A. BN.”
Tri Ang Pedal Jeep Celina, OH Make Offer
No pics provided. See examples here.
“Late 40’s early 50’s Army Jeep pedal car..all original
Make Offer”
1946 CJ-2A Toms River, NJ **SOLD**
UPDATE: **SOLD** Was $6500.
Appears worth a look.
“Clean 1946 CJ 2A Willys Jeep. Runs and drives great. Too many new parts to list Only interested buyers please.”
1942 MB Pennsburg, PA $8500
Could be an easy restoration or drive as is.
“1942 Willys MB jeep. 4 cyl, 4 wd, 3 spd manual trans. In great shape for its age. Clean PA title and currently registered and inspected as a classic. It is road worthy now and I do drive it occasionally. Always stored inside. Asking 8500 obo”
1946 CJ-2A Carlisle, PA **SOLD**
UPDATE: This is back on Craigslist. Last listed in 2013. Was $1500.
(09/07/2013) “1946 Willys This is a 46 Jeep body with some sort of old truck cab attached. The conversion was done may years ago and the body is in decent shape, with very little rust. I drove it into the garage about 4 years ago and have done nothing with it since. It will need new gas and probably the carb cleaned to make it run. 1500.00 firm. I have a clean PA title in my name.”
1951 CJ-3A Fresno, CA **SOLD**
UPDATE: **SOLD** Was $3500
“Sell or trade for a land rover, 1951 CJ3A with a Chevy 327, disc front brakes, winch, dana 18 with a manual 3 speed. Small lift 33″ mud tires, power steering, locked front and rear with 5:38 gears. Ruff and tuff just like a old jeep should be, new wiring harness. Tagged for the street but not a daily driver, great for the mountains or beach.”
1960 CJ-5 Middletown, IN **SOLD**
UPDATE: **SOLD** Was $3500.
This may be a good restoration project.
“1960 willys jeep, 10, 000. Original miles, all original except taillights, runs good, 4×4 works good, basically rust free, nicest original tub you’ll find, 1/2 metal top with doors, snow plow non powered, needs brake work”
1957 CJ-3B Huntsville, AL **SOLD**
UPDATE: **SOLD** Was $1200.
Might be worth a look at that price. Not all original.
“Great project
All original
Title
$1200”
1953 CJ-3A Johnstown, OH **Status Unknown**
UPDATE: Was $2500. **Status Unknown**
Has a tilt fiberglass hood.
“1953 Willys Jeep steel body with fiberglass hood
strong 427 with 4 speed trans
35 x 14.50 x 15”
Scheneker Snowplow Bristol, RI **SOLD**
UPDATE: **SOLD** Was $275.
Here’s a vintage Scheneker Snowplow at a good price.
“Complete 7′ snow plow off Willys CJ-2A Jeep. Includes the complete blade with skids, upper frame, lower frame, pump, hose, and pump mounting bracket. Works good. It is a nice design that includes braces for the Jeep frame and an easily removable lower frame to improve ground clearance. A small piece of the cutting edge is broken off on one side. The blade was a 6′ and was widened to 7′ many years ago. It could be easily cut back to 6′, but my Jeep pushes it fine. The pump originally mounted on top of the generator on the motor, but I made 2 brackets to attach to the original flathead motor or a Jeep Dauntless V-6. One of these with it if you need it. The unit was made by Scheneker Iron Works.”
1946 CJ-2A York, PA $750
It’s a project.
“I am selling a 1946 Willys CJ2A. This vehicle is in pieces as seen in the pictures. It does need work in some areas but overall is a solid project. Motor is the l134, I could not get it to turn over even after pulling the head off. Transmission and transfer case are good, tub will need replaced unless you really want to chop it up. Does not have title but I do have the serial number tag to obtain a title. Please dont waste my time, what you see is what yiu get. Will part out items if needed, email only.”
1955 Model? Cheshire, CT $800
Could be a diamond … or a piece of coal.
“1955 willy jeep. All stripped down & ready to be restored.”
1976 CJ-5 New Washington, OH **SOLD**
UPDATE: **SOLD** Was $300
Plenty of parts value for the price.
“76 CJ5 parts jeep, no title no motor good running gear make offer ”