UPDATE: **SOLD** Was $450.
These don’t pop up too often for sale.
“15×12. Bolt is 5 x5 1/2. 1/2 ford or dodget truck. Great shape, sweet on old cj5 or bronco or for sand paddles, have 2 sets i only need one.”
UPDATE: **SOLD** Was $450.
These don’t pop up too often for sale.
“15×12. Bolt is 5 x5 1/2. 1/2 ford or dodget truck. Great shape, sweet on old cj5 or bronco or for sand paddles, have 2 sets i only need one.”
UPDATE: **SOLD** Was $2000.
(07/16/2016) I believe that’s a Koenig hardtop.
“WIll separate top/doors and Jeep. $1,500 for Jeep. $500 for hardtop and doors.
UPDATE: Dropped price because of running status. Was running two weeks ago until I mistakenly added some diesel to the fuel tank. Tank has been flushed, carb cleaned and new spark plugs installed. Hard to start and have white smoke when running.
1954 Willys Jeep CJ3B with hardtop and doors. Original Hurricane F Head engine. Was running and driving two weeks ago. 4wd works. Shifts smooth. Needs brake work. I have a new master cylinder, just haven’t installed it yet.
I have replaced the water pump, key switch, starter switch, cap and rotor, points, condenser, coil, plugs and wires, temp gauge, radiator hoses and rebuilt the carb. It is the original 6v system and has a new battery.
Body is in pretty good condition for 60+ years. Has some rust and minor damage. Portions of floors missing, but sheet metal has been placed down so that there are solid floors, except for in bottom of toolbox. Hood was covered in fiberglass by previous owner.
Seats need to be redone. Previous owner made a bench type seat with passenger frame and rear seat. Have a bottom for drivers and have a passenger seat from a 2a that can go with it. There is a hand winch and tow bar on the front and Allstate locking hubs installed.
Clear TX title in my name and in hand. I am only the third or fourth owner and all previous were one family.
Only selling because I have put all of my time and money into a ’59 CJ3B. Bought this one for parts, but it is complete and was running so I don’t want to tear it up.
Does not include wheels and tires that are on it. Will include the five originals with tires suitable to make it a “roller”. Those wheels are shown in one pic with bad tires.
$2,000 cash for everything or best offer. For the right price, I will delliver the Jeep within 150 miles of Round Rock.
Willys Willis Jeep CJ 3b army jeep flat fender 2a 3a military jeep 4×4 off-road offroad CJ3B“
UPDATE: **SOLD** Was $1900.
The body has some holes.
“I have for sale a ’63 Cj3b. This has the original 4 cylinder, 3 speed, and 4 wheel drive. The engine turns over. The previous owner told me it fires up but I haven’t tried. This is an excellent restoration vehicle. I have a clean title in my name. Extra hood and a seat frame is included. This Jeep has wheels and tires that are almost brand new. ”
UPDATE: Price dropped to $2500
(05/29/2016) Has clutch problem and a V6 installed.
“This is a rare find.
This M170 ambulance is a front line 1/4 ton 4×4, 3 speed,w/ twin stick transfer case T 90 trans. Engine; Buick V-6,
no clutch,
101 wheel base,
20 in.longer than reg.
New tires, roll bar, top and doors, non stock seats.
Roller because of clutch.
Only about 4,000 made.”
UPDATE: Price dropped to $2000. Includes an overdrive. Seller needs gone!
“I have a project willies i need to sell today preferably its a 47 title with a 46 tub and a mid 60s 307 small block that runs well its got a saginaw 4spd with a granny low and an overdrive unit on it as well i just dont have time for the project and this is more than i want to work on it runs and drives just needs things finished on it! i have everything for it to finish it just no motivation im pretty firm on the price as if you were to part it out, it would be worth more. im also into trade potentially, the jeep does need some love but not much to get it road worthy i just dont have the time to do so would make a super fun summer ride!”
Stephen Stokes was kind enough to share this photo (via David Watson). It shows Stephen’s father, Fredrick Stokes, during his time in Japan with the US Army. The photo was taken between 1946-1948. If the bumper is accurate, it looks to be a GPW.
Jonathon McDonagh, part of the McDonagh Brothers team that hosts eWillys, spotted this cool FC build that was featured on PowerNationTV. Check on all the photos here:
http://www.powernationtv.com/post/powernation-ride-of-the-week-jeep-fc150
A photo of the FC before the build:
Photos from after the build:
Ted’s selling these two Newgrew plows:
“Two Newgren Single Bottom Plows with extra frames for sale
Both have very nice original Newgren ID tags
Both plows are in very good condition ,mostly complete
Missing Furrow or land wheels and one missing Coulter
I believe some of the earlier Ferguson and Deer Born type tractor parts are interchangeable and possibly Oliver too .
If anyone has any info on this I would be happy to include in post
$850 each but would rather sell all of it as a package for $1500 for everything
willysted@charter.net
I will be away till late wed but will return all emails
Can ship anywhere in the US through Fastenal if someone is interested
Located in Storrs CT”
UPDATE: Price dropped to $5000.
(06/28/2016) Includes a bed extender.
“Willy’s Jeep owned only by two people. Family bought in 1956. Has no rust thrus. Is in good condition. only add on’s bed extender and foot steps to get in.. Starts right up. Soft top included, in ok shape. Hasn’t been put on jeep in years.”
http://ogden.craigslist.org/cto/5721476047.html
UPDATE: **SOLD** Was $5000.
Looks good for the price. Appears to have a Bobcat hood.
“1948 Willys Jeep with small block 327. 3″ lift, new wiring. Call for more detail.”
UPDATE: **Status Unknown** Was $6500.
(06/27/2016) Looks nice. Listed as a 1949, but mostly likely a ’48.
“All original
100% restored.
Runs perfect.
Brand new tires”
UPDATE: **SOLD** Was $2500.
It runs. Could be a good price.
“’48 Willys Jeep CJ2a. All original flat head 4cyl., 3speed, 2spd transfer case. Only 61000 miles. Runs like a top. Also has metal doors for the hardtop. Good tires and brakes. Some rust. Has tow bar. Great hunting rig , gets good gas mileage.”
UPDATE: Was $10,500. **SOLD**
(06/20/2016) Looks good.
“46 cj2a black plate california car. original paint,top, engine,driveline. govorner on engine,rear pto. runs great. no rust.”
UPDATE: **SOLD** Was $20,000.
Not restored, but looks like a good refurb. It’s another example of the interchangeability between the CJ-5/6 and the Commando front clip. Has a fiberglass body.
“Fully restored, frame up restoration 1966 Jeep Willys – PERFECT CONDITION!
It’s a 1966 Willys CJ 5
Fiberglass body
41,000 original miles
Frame up restoration
3 speed standard
V6
Additional pictures can be emailed.
$20,000 or Best Reasonable offer. Serious inquiries only!”
One is more of a parts jeep, but both run.
“(2) M38A1 Military Jeeps. One is restorable and the other is for parts. Both run but neither has working brakes. Included in the sale is a complete master brake kit -9″, made for the M38A1 from Kaiser Willys Auto Supply which cost $494.99.The last photo is the boxes of brake parts.
The olive drab Jeep is very original with it’s 24 volt electrical system. Although painted over, you can still see the US Army markings on the hood. Floor pans NOT rusted through and the frame is in great shape.
The orange parts Jeep has been converted to 12 volts. It comes with a gas tank and the original orange hood.
Various other parts are included: Spare wheel, antenna mount, brand new steel tubing frame to hold a canvas top and it’s associated clips, etc.
Both Jeeps have brand new batteries.”
UPDATE: *SOLD* Was $1250.
Runs.
“To many new parts to list, good hunting or farming Jeep. Clear title”
UPDATE: **SOLD** Was $4000
The body might have some rust along that passenger side. The front frame rails have been extended.
“1947 Jeep Willys
Nearly all original. 6 volt system
A2 Farm Version. Rough body, not restored or it would be $12k.
Painted with my Army Unit (160th SOAR) Google it
L134 motor. Starts right up, runs good, goes straight down the road
Very few of these on Maui, none like this one, none at this price.
Shipped in from WA last year. Clean title. Unknown miles.”
UPDATE: **SOLD** Was For Trade.
No description of jeep provided.
“Trade for 4×4 quad or small fishing boat and motor”
UPDATE: **SOLD** Was $3000.
Includes extra parts and a pto winch. It’s a project.
“For sale is this rare 1962 Jeep FC170 4×4 truck, I have an extra frame, rear end and front end that can go with it, motor, tranny and t-case are still in the truck. Call for more details price is $3000 for all. Truck will come with bill of sale.”
A rock crawler from an M-170? Not something you see every day.
“Dana 44 full width axle, Hydrologic steering, 38” super swampers, full cage, front bumper air tank, has parts for an on board welder, small block 400 w/ turbo.’
UPDATE: Price now $14,500.
(03/25/2016) Looks in good shape.
“1946 CJ3B Jeep Willy’s Jeep
Complete frame-off restoration. 1954 Willys Jeep. Email with questions.”
UPDATE: **SOLD** Was $1500.
Listed as a 1948, this looks to be an MB.
“For Sale.. NO Trades 1948 Jeep Willys Overland. rusty but solid, some repair panels already in. CLEAN TITLE $1500 O.B.O. located north of Owen WI. Call or Text.”
What’s the contraption in front of the body? Is that PTO related?
“1947 Willys CJ 2A. Tore apart to restore, my son lost interest. Great restoration project or for parts. Serious inquiries only!!”
Looks to be a DJ-3A body on a CJ 4WD chassis. While a true DJ-3A installed on a 4WD chassis from the factory has yet to be found in the US, the DJ-3A group did learn about a DJ-3A with 4WD that was sent overseas. So, we are wondering if one or more were sold in the US as well.
“Frame off restoration, motor rebuilt, new axle seals and bearings, all new brakes, will lock up all 4 wheels. Body in really good shape, very usable, solid floor.
Runs and drives great, still needs lights wired, gages, a roll bar, maybe a windshield. All the hard work is done, ready for finishing touches.
$2500 or best offer, more than that invested.”
UPDATE: **SOLD** Was $1500.
(07/14/2016) It’s a project.
“1953 Jeep Willys project vehicle, ready for owner who wants to get her back on (or off) the road! V8 conversion with a 283 from a 1957 Chevy. Most engine parts included but not installed, the block is installed. Transmission needs work.3″ shackle-over suspension lift. Corbaeu 5 point harness racing seats included. Needs a lot of love, but definitely worth it, so please call or email!”