UPDATE: The weather was perfect, cloudy, not so hot, and windless, for painting the chassis outside.
================================
It’s been a busy few days. I completed the sidebars and netting, then washed the frame. It’s drying awaiting a new coat of paint. While I’d prefer to disassemble and properly clean and paint everything, that’s just not possible at this point.
There’s nothing much fancy about the side bars. A bolt secures the back of the bar and acts as the pivot point. A 3/8’s pin holds the front in place and is pulled to release the bar so a person can enter/exit the jeep. The netting is held in place at the front by a seat belt buckle. Undo that, then pull the bottom bar forward slightly, and the bottom of the net comes loose, then a person can swing the netting onto the top. (note, this phone was taken before I welded a short horizontal tube which will hold the back of the top netting bar in place .. the orange clamp was just to figure out where the tube should go).
With the bars and netting done, the mods are pretty much complete. Now, to clean, paint, and assembly. Hopefully, everything goes back to gather as it did before …
Here’s the chassis a little cleaner. My goal is simply to cover the green and paint the bare metal.
The front tires will go on some aluminum rims, while there will be desert dogs in the back. The back rims remain undecided. I’d rather not use the hurricane finned rims for the rear, but don’t want to crack them. I have some other aluminum rims for the back, but they are six lug, while the rear axle is now a five lug drum.