This may be worth a look.

https://capecod.craigslist.org/cto/d/cummaquid-1950-willys-jeepster/7647794741.html

“This is a basically sound Jeepster that needs work. I put in a rebuilt Jeepster Jim transmission, but it still needs to have the engine wired before it will run. I am including a new wiring harness for the entire vehicle. This is the four cylinder Jeepster and ran fine before the wiring deteriorated. This Jeepster will have to be towed.”

It’s had some updates, but needs some more work.

https://www.facebook.com/marketplace/item/952317046078915

“1949 Willys Jeepster project. Mustang II type front suspension, 8 inch Ford rear axle. Manual disk front brakes all done with dual master cylinder. Rust in the rockers and cowl has been cut out patch panels are there. Stock steering column attached to rack with Limeworks 700r4 column shifter. 700r4 transmission mount. Almost 2 sets of body chrome trim, aluminum radiator plus original radiator, extra grille, rear pan and windsheild frame. $5500 obo you see it it’s avaible. Clear green title in my name.”

This is supposed to run and drive. Current bid is $500 (4 days to go).

https://www.copart.com/lot/58590703/clean-title-1949-willy-jeepster-mn-minneapolis

Continue reading →

This could be worth checking out if you have a Jeepster with a bad body.

https://wichita.craigslist.org/pts/d/wichita-restored-1950-willys-overland/7639118948.html

“Restored body only. No title, no motor, no transmission, no interior, no top, Does have axles.”

It looks like the rear area has been customized. Might be worth a look at this price.

https://www.facebook.com/marketplace/item/985154409342242

“V6 ran when parked 3yrs ago,needs restored.”

This is supposed to be a solid Jeepster, but will need some engine work at the very least.

https://www.facebook.com/marketplace/item/3119929124976440

“Decided to sell our 1950 Jeepster, 6 cylinder. Even has the rare “6” emblem on the hood. Clean TN title in my name. New over the past year: tires, brake master cylinder and wheel cylinders, new aluminum radiator, rebuilt starter, rebuilt water pump, carb rebuilt (twice), plugs, plug wires, distributor cap, button, points. The engine was supposed to be rebuilt before I got it. It idled, but wouldn’t rev, prior to all the work. Slip the clutch and it pulled in 1st and reverse in the garage. Also has the overdrive unit. After the work……..nothing. I added an electronic ignition conversion, nothing. We’ve owned this for several years, always stored inside. We’ve come to understand that we will not get this car up and running and have moved on to other projects. This is a solid car that just needs someone’s magic touch, no side curtains (we have frames), and no top (we have the bows on the car).”

Bill shared the nice looking Jeepster at what might be a pretty good price, though the gauges and overdrive need to be wired. It was also highlighted on Barn Finds.

https://www.facebook.com/marketplace/item/977492693269519/

“Nice looking 1950 Jeepster, runs has good brakes, converted to 12 volt, has disk brakes on front , new top not installed, dash gauge’s needs to be wired up, is a 3 speed with 3 on the tree, it does have o/d but it needs hooked up, this vehicle still has the 4 cylinder hurricane engine, interior good body work has been done in the past, tires good. mileage unknown.”

This project or parts Jeepster was spotted by Bill.

View all the information on eBay

“Up for auction is this 1949 Willys Overland Jeepster. Very solid sheet metal, I could only find two rust through spots on it, one behind drivers door and one on the left lower hood which I took pictures of. It has light surface rust that should sand off easy. The engine turns freely, trans shift through gears and it rolls very easy. It does steer too. Gauges busted out. Car is pretty complete. Hotrod, ratrod, or restore. The serial number indicated it is a VJ2 Jeepster that was  built right around the cutoff date for 1948 models and the beginning date of Nov. 1, 1948 for the 1949 models.  With the serial number tag under the edge of the dash,

Continue reading →

This appears to be a project.

https://www.facebook.com/marketplace/item/888388872435564

“Top end was rebuilt on engine but the new oil line broke causing the lower end to knock. May just need bearings which are easy to install. It was a Shriners car, so interior is not original. Carpet is indoor outdoor. Not sure of rust? Top bows are rusty and not installed. And has all but one fender steps. Rare car. Fun to drive. 6 volts, except to start is 12 volts. Not sure why they didn’t just convert it to 12 volts. Looking to sell or trade toward a 67 to 72 C10/c20 plus cash. Looking for a 67-72 c10. Box full of trim and various parts including a used working speedometer. My hands don’t work anymore so I’m not able to repair it. It’s in East Wenatchee”