UPDATE: **SOLD** Was $10,250.

Looks solid, though this might have a coating on the exterior (see the fender pic).

“1949 Willys CJ3A. 4 cylinder Go Devil. Amazing shape lots of extras. Engine rebuilt. Compression 120 all cylinders. Transmission works perfect new seals and pinions. Locking front hubs. Rebuilt shifters. Brand new clutch. Over $10k in receipts. If it needed replaced or fixed I did it: New bearings all 4 corners. New master cylinder. New brakes. Manila Rope. Shovel and Axe. Rebuilt stearing box. Electronic distributor and one extra. Complete rewire to 12 volt. New starter. New Alternator, New horn. New Air box. New gas tank and sender. All new gauges. New seats and belts front and rear. New tires and powder coated wheels. New parking brake. i have a bimini top. mileage unknown but running gear is in great shape. Lots of extras included.”

This supposedly ran before the battery and radiator was removed. I suspect the rear panel was replaced with a non-tailgate panel at some point.

https://www.facebook.com/marketplace/item/225688750549338

“his is a 1951 Jeep CJ3A. This was my father’s jeep that he partially restored. The jeep yard drives.

Engine runs well but smokes when warm. Possibly the oil control rings are stuck. My dad took the engine out and had it rebuilt but never fully reinstalled. The Jeep sat in the barn for about 10 years without running. Pictures of the engine bay were taken before I put back together with all new ignition components.

Electrics have been converted to a 12 volt system. (started is still 6v)

Fuel tank is currently of of the vehicle, I didn’t want to put gas in the tank and have it sit. Tank looks clean. Continue reading →

UPDATE: Still Available.

(11/07/2023) The price doesn’t not include the winch, but does appear to include the Warn OD.

https://www.facebook.com/marketplace/item/359162849935326

“Asking $3500.00 OBO without the winch. Engine/transmission/transfer case rebuilt 20 years ago. Front end rebuilt 25years ago. Only put about 1500 miles on it since rebuilds”

Listed as a 1950, this has some updates, but also appears to have a CJ-2A body.

https://www.facebook.com/marketplace/item/627050782872103

“1950 army jeep, 1600 miles Chevy 4 cylinder motor, runs good tops out at 50mph, custom seats and top, perfect hunting vehicle, 7000 obo”

Unclear how much value is here.

https://www.facebook.com/marketplace/item/660997219543712

“1950 CJ2A Willys Jeep project/parts 99% complete, missing windshield frame Paint is bad, body is pretty good with minimal rust in the body/tub F head motor, not sure of its condition Does not run, will need to be trailered AS-IS, NO TITLE, BILL OF SALE ONLY $850 OBO CASH”

Looks ready for the Cascades.

https://www.facebook.com/marketplace/item/860294805764725

“1949 Willy’s Jeep 289 Ford V8 with Holley fuel injection carburetor. 4 speed Granny low Warn overdrive Dana 44 axles with posi in rear. Power steering Disk brakes on front axle, drum on rear. Has custom aluminum large fuel tank under rear seat. 33×12.50 tires about 90% tread”

Hasn’t been driven since the 90s.

https://www.facebook.com/marketplace/item/871856134529494

“1950 Willy’s It drove when we put it into the garage back in the 90’s. Clean title. She’s a great project car.”

This includes a 1953 M-100 trailer.

https://www.facebook.com/marketplace/item/2786579044827969/

“fun running, reliable driver 12v has new tiers all around the trailer is a 53 m100 hand brake works”

Looks solid, but needs brakes addressed.

https://www.facebook.com/marketplace/item/591578513168429/

“1949 jeep Willys CJ-3A. Runs and drives, but does not stop. Needs brake work. ”

Looks solid.

https://www.facebook.com/marketplace/item/681820117147732

“Professionally restored by army jeep specialist T90 transmission, 3 speed manual Transfer case is an 18 L head engine, otherwise known as a flathead, has been professionally reworked at an engine shop and has less than 100 miles on it- original mileage is 13k Dana 25 front axle Real axle Dana 44 PTO Carter w/o carburetor Choke and floor mounted foot starter Runs great, ready to drive home or out for a ride in the desert! (But can be delivered) The top shredded while bringing it up north, price reflects the need to buy a new one, still have all the hardware if your a do-it-yourselfer.”

UPDATE: Price dropped to $2305.

Looks like someone did a spring-over on this one, but decided to keep the drivetrain dropped.

https://www.facebook.com/marketplace/item/1317085882519546

“1954 Willys Flat Fender With everything except the engine . Bought for a project just don’t have the time .”

Runs.

https://www.facebook.com/marketplace/item/2171525539723520/

“1949 willeys CJ2 on none opt with DMV does run and lots of spare parts (cam shaft , head , transmission , ECT. ) 4000.00 FIRM”

The seller has a lot of money into this, but the jeep remains in pieces. The pic below was taken prior to it being disassembled.

https://www.facebook.com/marketplace/item/244281111765795/

“Hello, I have a 1952 Willys CJ3A project for sale. I have had it for about 25 years now and don’t see myself finishing it anytime soon. So it’s time for it to move on. I have about $12k into it and it’s still in pieces. I bought the replacement panels and $4k in parts (see lists in photos). I also had engine completely gone through, machined, and professionally rebuilt ($3k) with hardened vavle seat so it is good for todays gas. It has a Dana 44 rear axle, original heater, professionally rebuilt front and rear driveshafts, and quite a few spare parts including a spare transmission and transfer case. I also have a full steel hard top (no side doors) and a half cab/doors. Have clean title too. I also attached a couple photos of when it was together. I would like to get $6k because there is $4k in parts on the lists alone, $3k in the engine, plus everything else. Open to offers/trades especially a for 55’-59’ Chevy/GMC truck driver/solid project. Goose neck livestock trailer w/lvg qrtrs.”