UPDATE; **SOLD** Was $600.

Those appears to be the mudflaps hanging from the back.

“NO TITLE, Serial Number 88306, Drive train is fine (axels, trans, engine, brakes, transfer case) has PTO with no lever or propeller shaft. Good oil pressure. Set up to simulate an MB. 60+ year old Body is far from perfect. 8 inch wide wheels with dry-cracked tires. Good to run on a farm or for hunting and trail riding. Mud Flaps & Tow bar goes with. Must go soon. Advertised locally. Drive it on your trailer and get back home to have some fun. $600”

There’s a variety of parts and projects here with prices that vary.

“1st jeep has the most potential and while the picture does not show it, it has a grille and other parts that can be put together to make a good one. It has rear diamond plate for the corners and diamond plate for the sides. It does have a windshield that needs put together. No seats or titles on any of them. It has saginaw front end which is optional I will keep it if you want to dicker. If you plan to install a bigger engine I will keep the engine and transmission and transfer case too. Engine is a L head than turns over by hand but someone got the carb and starter. It has a roll bar of sorts. Price depends on if you want the saginaw and engine. $300 with out all that. $650 with all that.

2nd jeep is a basket case and frames front has cracked totally off. But it has a round cross bar that can be used on the first jeep that some idiot cut off the original and put L iron to fit the saginaw on it. Or you can weld it back together and start a rebuild of a second jeep. it has axles but no power plant or transmission or transfer case. $150 for it.

The third is just a body and hood. It was a rare long body that someone cut down to a CJ3A size. Welds need to be finished on that part. Body could be used on one of the other two if you wanted. Might have another windshield in need of repair for it too. $200 for it.

As I said no titles but they can be gotten. I believe data tags are on one at least. I have extrea transfer cases that may need rebuild for $100. And some other extra parts for those that buy all three of them. Including axles. Have other small parts that I will make deal on if you buy all. I just need parts to finish my 2A. Might consider trading for things I need for the 2A like seats or guns or other old interesting item. Especially jeep PTO’s for the front and back or an overdrive. Or Jeepster parts from 48 and 49. I am keeping the roll cage for the 3A for now. But with the right offer will sell it too. It is one that is done well with sides that fit the contour of the CJ2 and 3A frame. $450. These are projects as you can see. And as I said I have hundreds of various small parts too for sale. And for the right trade or take all I will think about a better deal. Also have a F head that needs gone through. It used to turn over by hand but now doesn’t. has a regular oil filter system on it for spinning oil filters and upgraded carb. Long story. $250. Had it in a flat fender and it ran then.

http://wenatchee.craigslist.org/cto/1517486759.html

UPDATE: **SOLD** Was on eBay

The truth in advertising here?  “1952 Willys Overland CJ-3A runs, drives, might stop.”  I can’t say I’ve ever seen a grille damaged quite like that.  Check out the gear shift in the third pic.  It’s also a mix of CJ-2A and 3A.

“Here’s the good: This vehicle runs well. -Starting is accomplished using the factory center foot pedal starter engagement. -The following have been replaced recently (last 4 months) -fuel tank, intake, exhaust manifold, intake valves, head gasket, spark plugs, points, condenser, master cylinder, filters, and oil. -the carburetor and fuel pump have been rebuilt recently. -starts, steers, shifts, rides fine.  doesn’t stop well right now. (wheel cylinders need rebuilding, i have the rear kits.) -transfer case works well and is twin stick case. (high/low and 2/4 wheel drive.)”

No pics and no description.

“PH 559-579-2288”

http://fresno.craigslist.org/cto/1501199320.html

UPDATE: **SOLD** Was $4500

Check out the length of those front shackles.

“For sale is a 1952 Jeep Willys CJ 3A. Engine is a buick V-6. Lots of work done on engine gaskets etc. Rubbers are 31″ MTRS need to be replaced. 16″ Eagle Alloy rims.”

UPDATE: **SOLD** Was on eBay.

“VERY NICE! 1953 CJ 3A WILLYS. RESTORED BODY OFF-ALMOST-NUT & BOLT RESTORATION. 16,267 MILES. PRETTY MUCH EVERYTHING ON THIS JEEP HAS BEEN REPLACED WITH NEW OR REMAN PARTS. REMAN MOTOR. COMPLETE CLUTCH SHOCKS & SPRINGS. ALL NEW BRAKES & HYDRAULICS. RUST FREE ORIGINAL BODY. NEW WINDSHIELD ….”

UPDATE:  Price dropped to $1000

This is missing a tranny and tc, but does have some later model running gear with 410 gears.  There might be some value here.

“1957 willys $1200 obo has 4.3 carberated setting in it, but no tranny or transfer case, and no interior. has good dana 44 in the rear and a dana 30 in front, 410 gears trust axles. please do not email it is not mine. call mike @ 218-731-2321 for any questions”

http://fargo.craigslist.org/cto/1487051729.html

It’s a project.

“Up for auction is my 1949 Willys Jeep CJ3A. This is a project that I just don’t have time for, due to Deployments. This Jeep runs, the tranny shifts, and the 4 wheel drive works. I do give a guarantee. Just hook up some fuel and a battery this baby will start. I discarded the body because it was too far gone to repair. You can order the body and practically every part for this Jeep through companies like Kaiser Willys. I have purchased a new grill and steering wheel along with other misc. parts. The window frame is in OK shape and will need new glass, it’s flat and will be easy to replace. All this Jeep needs is to be sand blasted painted and ready for body. I will help in the shipping process, I would consider delivering within 250 miles of Fort Campbell KY for 1.00 per mile. I also have a V8 conversion kit for this Jeep if interested. Happy Bidding please e-mail or call me @ 910-309-1623 for questions.”

View all the pics on eBay

UPDATE:  New pics.  This was listed at $15,000. Status Unknown.

“Brand new body on 1986 CJ7 frame. Late model rear ends, transmission and transfer case. New 9000 lb. Ramsey Winch. New Best top seats and top with doors. New Roll Bar. New Tires. Needs nothing!!!!! SERIOUS INQUIRIES ONLY!!!!!Joe”

Sounds like you could make an offer and walk away with this stuff.

“I have a frame that is in great shape, and a tub that needs some TLC. The front axle is the Dana 25, and the Dana 41 is the rear axle. I have about $1200 in this and i am looking to move on. I am interested in some trades so let me know what youve got. I am specificly looking for R/c cars if i cant get cash. NO NITRO I am into crawlers and short course trucks. also wheels tires and jeep cherokee and wrangler stuff
HIT ME UP, MAKE OFFER! dont be shy i need to get this out if the yard.”

http://inlandempire.craigslist.org/pts/1479962414.html