No pics provided.

“1947 jeep willys flattie/flat fender for sale… started frame off restoratiin with frame sand blasted and painted. setup and had ford small block v8 installed but sold mustang motor and project will need engine and bellhousing. has trans and transfer case with driveshafts and everything else all done. body was sanded down for paint, was a southern tenessee vehicle with very clean body. has full roll cage and lift. looking to get 2500.00 for it or trade for comparable valued ski doo, polaris, arctic cat, yamaha snowmobile…”

http://appleton.craigslist.org/cto/3511959437.html

UPDATE:  **SOLD** Was $2500

(10/31/2012) It runs and drives.

“Straight 6, original running gear, 3 inch lift, everything works, A lot of fun to drive. Obviously need new seats but the tub is in good shape with minimal surface rust. We don’t have the time right now and I would hate to see it rot away in the yard. ”

UPDATE: **SOLD** Was $1500.

This runs and drives.  I am sure the steps are strong enough to support the rollcage should it roll, right?  It’s possible that is a CJ-5 cage someone had jury rigged into place.

“1946 Willy’s with original flat head motor. this unit starts and drives. No low ball offers.”

UPDATE: **SOLD** Was $2000

Hard to see $2000 of value here.

UPDATE:  Still Available

(11/08/2012) I hope there are more parts than shown in the picture.

“lots of new parts 3600 is what i have in it . i have all of the jeep the tub is the only thing not useable
the frame has been sandblasted and prime and panted all new brake lines ,master,wheels cyc
all seals been done new tires and the rims come off a 1980 powder coated , i did add more parts from the last post
send me a email with a phone no. and ill get back asap”

http://morgantown.craigslist.org/cto/3506876514.html

UPDATE: **SOLD** Was $800.

This sports some old mini terras.

“FOR SALE IS A MID 45 WILLYS JEEP ARMY TYPE WILL NEED RESTORED CALL FOR INFO”

UPDATE: **SOLD** Was $2500.

There may be value here, but it needs brakes.

“1945 Willys Jeep, 6 cylinder motor, runs and drives, needs brakes. Title in hand
$2500 or trade for nice four wheeler”

This is a mix of parts.

“I picked this up earlier this month on impulse,but not sure when I will find time for it.

1947 Willys CJ2A Jeep. It has a clear Michigan title! The body has all new floors and sub-structure,and most of the rust has been repaired with new metal but welds still need ground smooth. It is mounted on a nice clean M38A1 frame and has a brand new Pro Comp 2.5″ lift. It has CJ5 Dana 30/44 axles. It is a project. Have most parts with it,plus extras. There is a carbureted 4.3 V6 in it,with a T14 trans and Dana 20 transfer case. More not listed. This is a great project,all of the hard stuff was already done. I am asking $1200

Needs towed,and body is only sitting on frame right now.

Lowball offers will not even be considered. Will consider trades though for older 1950`s-1960`s step van,Willys Wagon,F100,etc.

Located in Burbank,IL 60459

Jim 708-289-7686 call or text.”

http://chicago.craigslist.org/sox/cto/3498247375.html

UPDATE: **SOLD** Was $850.

It’s a project.

“Willys CJ2A restoration project. All original running gear installed in rolling chassis, body is complete with the exception of a tailgate, original seat frames with aftermarket rear seat.No wiring, fuel tank or brake lines. Consider trades for tractor implements, rock saw, guns or ??

No pics provided.

“I have a 46 jeep. Great tires no motor everything else is there. Everything was working when the motor blew. $1500 obo call or text anytime can send pics . 6628890413”

http://northmiss.craigslist.org/cto/3494390579.html

This poor jeep is melting . . .

“For sale: 1940’s jeep willys parts I have the complete jeep just let me know what you need and I will let you know. I have a complete rolling chassis with motor that runs. all of the body work is shot the grill may be salvageable but that’s it. I have two front fenders that are extra that are in good condition. the jeep also has a homemade plow on the front. the plow itself is not homemade but the mount and the lift are. the lift is a manual hydraulic lift that you pump by hand between the seats. I tried it and it works. I did put a new 12 volt coil on it and a distributor cap and it started up. the carb needs tuned to run correctly but it will run and you can hear it if you want. I was going to use it as a woods beater with out the body but I do not have the time to mess with it. I will sell individual parts or whole but i have no title. I m asking $500.00 for all or we can discuss price on the parts you need. please no low ball offers for the whole thing I can take it to the scrap yard for not much less than what im asking. call: four12-five82-two318”

http://pittsburgh.craigslist.org/cto/3489149678.html