UPDATE:  **SOLD** Was $1595.

No title. There might be some parts value.

“Selling my 1949 Willy’s Jeep. Original 4cyl engine runs great, transmission and transfer case all good. I bought it a couple years ago to fix up, but have too many other car projects and don’t have enough time. It should be a fairly easy one to road/trail ready. It looks like someone was going to lift the body off the chassis, so needs wiring spliced back together, brake line reconnected, rear drive shaft re-installed and a few minor other things to make it roadworthy. It does drive, now, with only the front drive shaft connected. No title, will sell with bill of sale. Serious offers considered, cash only.”

UPDATE: Was $5000.**SOLD**

(07/06/2013) It looks good, but probably needs another rebuild.

“This 1948 CJ2A Jeep with a flathead 4 was actually restored over twenty years ago, then parked in a barn and never driven again. It probably has only 10 miles on the new engine. Of course the paint is shot and all of the seals will need to be redone etc, but overall it is in good shape. It has no rust. Please phone with further questions or to come and see this Jeep!”

UPDATE: This is still available.

Glenn spotted this jeep.

“Estate sale. Partially restored and recently running; needs a fuel pump but otherwise road worthy.”

http://nh.craigslist.org/cto/4104272801.html

It runs and drives, but boy is that tailgate beatup!

“For sale is a 1946 Willys Jeep CJ2A. This is a project that needs to be finished. A lot of mechanical work has been done, and below is a list of items that have been repaired, and still need to be repaired.
– 1951 engine – runs good, has small oil leak
– 1951 3-speed transmission in very good shape
– Resealed transfer case — good shape
– Drive shafts and u-joints in good condition
– Front and rear axle are in good shape
– Front hubs lock and unlock
– Excellent, clean gas tank
– Body has minor rust
– Needs steering work
– Needs brake job and parking brake cable
– Needs driver side windshield
– Needs rewired
– All original under hood, except for 12 volt alternator and starter
– Has original air cleaner
– Has good radiator and fan shroud
– Has tow bar
– Has “jerry can” carriers on tailgate
– Windshield frame has been welded
– Has later model bucket seats — right seat folds foward
– Has spare tire and bracket
– Has 4 original jeep wheels
– Comes with Bill of Sale

This jeep is excellent for restoration or fix-up and use. Call Dave at 316-393-1055.”

http://wichita.craigslist.org/cto/4099004298.html

The engine compartment looks nice.

“FOR SALE : 1948 Willy’s – New Tires, New Wires, New Seats, Rebuilt Engine, Comes with top shown in picture, and full top with doors not shown in pic. 4X4 works great. Runs great, all lights work including blinkers, heater blows hot! We’re getting close to a PCS, so she needs a new home! $4000 OBO Serious inquires only please!”

http://cosprings.craigslist.org/cto/4098909746.html

It looks like the tank has been moved to the rear.

“For sale is my 1948 Willys CJ2a – $4,000.00. Great little jeep for driving around town and catching everyones eye or driving back in the woods to get your deer.

The Good:
It has all the original running gear (all the gears R, 1-3, low/high, 4×2 and 4×4 work)
The body has been redone to remove all the rust and replaced with new metal.
It has about 30K miles on it and runs great.
Stops well with solid brake system (original drum brakes so doesn’t stop on a dime like modern cars, can send a link for a conversion if you like, but they work fine)
Paint is Jeep Rescue Green (the green that Jeep is currently using on their new Wranglers)
Clean and Clear title in hand!

What needs to be done:
Exhaust, no muffler on it right now. I can send you a link where you can buy a complete (from header to tailpipe) orignial exhuast for 180 bucks.
Fan belt squeeks (old dried out fan belt may be replaced just depends on if it sells before i can get to the store and get a new one)

For less than the price of a 4 wheeler you can do all the same great stuff and drive it on the road with some style. Serious Inquirys only please 704-880-5939, love to talk about the jeep but can’t do it with everyone.”

http://charlotte.craigslist.org/cto/4099961604.html

UPDATE: Was $950. **SOLD**

This is apart.

“For sale is a 1947 Jeep CJ2A project. Major components removed. Rust repair started. Usual rotted floors, but includes new floor pans and braces from Walck’s.”

UPDATE: **SOLD** Was $2400.

Unclear if it runs.

“For sale is 1948 cj2a willys jeep, this vehicle does not have title. Bill of sale only, the willys has all major components less the air cleaner, it was converted to 12 v and does have engine transmission, transfer case, axels, and all that. The two front seat frames are there, and has two bar, body does need work but is not the worst I’ve seen. Very doable project, the jeep ran in 2006 but I have not the time to get it moving again. Will consider any reasonable offer.”

UPDATE: **SOLD** Was $1000

There might be some value here.

“For sale 1946 CJ2A Jeep. Has title. The jeep ran a few years ago when it was parked inside my shop. It has not moved since. . .time to sell. The transmission or rear diff is now locked up due to sitting for years. Jeep has lots of rust and bondo, great for parts or project. I am asking $1000 NO EMAILS PLEASE ”

No pics provided.

“MUST SEE!! 1948 Jeep Willys CJ 2A totally restored and body all frame restoration. 4cylinder engine, red in color, 50 miles put on since completed! Is kept in garage and only used on weekends for fun. Jeep is in excellent condition.”

http://newlondon.craigslist.org/cto/4099294863.html

UPDATE:  Was $5000. **SOLD**

(10/17/2012) This is a project, but has a rebuilt drive train, brand new frame, and brand new body.  I haven’t looked at it, but if you are interested, I’ll run over and check it out.

“1946 CJ-2A Willys Jeep Project, this is a great project, most of the heavy lifting is already done. Includes:
-New AFW Frame
-New OMX-ADA body with Willys stamped hood & tailgate
-Tilt wheel, Saginaw steering conversion
-Original drive train (completely rebuilt by local pro)
-Roll bar and weld-in front cage (not welded up yet)
-New wiring harness
-5 steel wheels & good tires
-Some other bits & pieces
-Tow bar”

UPDATE: **SOLD** Was $2100

“Jeep has original flathead four cylinder, original trans and transfer case as well as axles. It has all matching serial tags, frame, firewall, etc. The body has some rust repair needed but can be fixed by someone with the knowledge and skills. I have a roll bar for this model in mint shape and original seat frames. It has been a family project for a while and we just don’t have the time for it. We are mainly looking to sell but may trade for a quad or motorcycle, maybe something else? I have all DMV forms to register and drive on the road when it is ready. It won’t take much it ran fine about ten years back when it was parked.”

It’s a mix of 2A and 3A parts. It is missing the front parking lights. Auction occurs October 8, 2013.

http://www.auctionzip.com/cgi-bin/auctionview.cgi?lid=1868016&kwd=willys&zip=&category=0

Marc spotted this flattie for sale.

“My son Jarred spotted this for sale in Springs (where I live) yesterday. We both went to look at it today.
Would you please post this on eWillys Dave.
It is a 1947 CJ-2A with s/n # 88706 being sold privately at a second hand car dealership (Anrecha Auto, Tel. +27 11 362 2243), so I have absolutely nothing to do with this sale. Maybe someone from here (RSA) will see the post and she will go to good home……………if only I could buy her I certainly would.

1) No data plate in engine bay, only the frame tag is still attached.
2) The type plate in the front passenger side is MIA.
3) Engine has been replaced with a Toyota 2.1 4Y petrol engine (installation look neat)
4) Gearbox set up looks normal but the salesman did not know the type but said the owner stated it was Toyota??
5) None standard fuel tank, it is home made but looks the part and I think it may be stainless.
6) Aftermarket CJ-2A windscreen.
7) Non standard tail gate mounted spare wheel which has broken the tail gate which has been
modified with other hinges.
8) All seems straight but the paint job is a “look nice”only as there appears to be body filler in
places and there is visible rust all round.
9) 3 small tail lights fitted on both left and right sides.
10) Top hat sections/hat channels have seen better days as they have rusted through.
11) No speedo but the other instruments look non standard.
12) Body has been lifted, by what looks like 2-inches with round rubber blocks to clear the
engine height for the hood/bonnet.
13) R 65 000 South African rand’s appears to be a little harsh for what this is and the overall
condition.

UPDATE: **SOLD** Was $650

(09/11/2013) It looks like there are is a hole in the floor.

“i have 1948 willy jeep 2wd mustang 2 front axle an it is set for v8 hook up an body an hood an both front fenders grill windshield the rear axle is sold but have a crown vic rear end that goes with it asking 650.00 or best offer or some trade”