UPDATE: **Status Unknown** Was “no price”
Fiberglass body looks fairly unmolested.
“Rolling chassis with motor and transmission.
Parting out fiberglass body.’
UPDATE: **Status Unknown** Was “no price”
Fiberglass body looks fairly unmolested.
“Rolling chassis with motor and transmission.
Parting out fiberglass body.’
UPDATE: Still Available.
(11/07/2016) Has rear hubs. It’s a project.
“I am selling this old Jeep Willys project. I bought this vehicle with the intention of restoring it but U
I don’t have the time to finish it. Straight body, I reconstructed the carburetor, replaced the head gasket, changed the radiator, changed bushing to the starter. New water pump, thermostat, radiator hoses, spark plugs,. The engine is ready to start, it has good compression. No title, no trades. ‘
UPDATE: Still Available.
“for sale a 1946 willys jeep jc2a non-op title it does run has brakes needs a little tlc original motor i don’t know the miles on it good project $3000”
UPDATE: **SOLD** Was $1500.
(11/15/2016) It runs.
“Jeep Willy’s 1948 4×4
4 cylinder runs
Hunting, off road, parades.
$1500 as is”
UPDATE: Still Available.
(08/14/2016) Engine looks in good shape.
“1949 Willys Jeep, complete, clean title, has hi-LO hydraulic pump, engine is free $1500 firm”
UPDATE: Price dropped to $3300
Joe-in-Mesa forwarded this ad. He also spotted a strange collection of clothes pins within the engine compartment. Can you see them? Any thoughts why they are there? Maybe keeping the gas line away from something?
“1947 Willys CJ-2A Jeep. There is a long story behind this jeep. The short of it is, my father purchased it in 1948 from a lady that thought it had blown the engine. I took it over in 1973 after it really did have a blown engine. Restored it and used it as transportation all over Arizona through college years. It sits a lot now and needs a good home.
Mostly original. Besides TLC it needs the radiator repaired and left front hub replaced. Besides those it is in good mechanical condition and is mostly original. The 134-4 cylinder engine runs smooth, and the T90 transmission is like wise in good condtion. Quite a few extra parts including springs, axles original hubs, etc.”
http://flagstaff.craigslist.org/cto/5896443289.html
UPDATE: Still Available.
(11/16/2016) For the price it isn’t very polished.
“1946, CJ2A, Runs, Drives, Stops, driven on weekends, new battery, new brakes, new alternator, new shocks, everything works, it starts every time, 4 wheel drive works, new seat cushions and covers, windshield folds out for manual A/C and also folds down for safari. Garage kept, If interested please email name and number, I will call you back, if posted it is still for sale, ”
Hasn’t run in a while. Looks like a Sears hardtop.
“I have a 1947 willys CJ2A Has been setting for a long time. Comes with a new fuel tank and sending unit a second frame set up for Chevy v8 and disk brakes and power steering brakes on second frame brakes are bled. Lost interest.”
Not sure there is much value here.
“old Willy’s jeep needs lots of work as you see or use for parts call or text.”
UPDATE: **SOLD** Was $6000.
(10/09/2016) Has 151 rims. The floors look patched, but I can’t tell for sure.
“4 Cylinder Flat Head
3 Speed Manual on Column
4 Wheel Drive”
Jim spotted this one. No engine. Looks like it has a Sears aluminum top.
“1946 willys jeep. Body is rough. No motor. Great for yard art. No title. $600 firm. Cash or Trade for pre 1960 vehicles Only. ”
Jim spotted this ad. Seller also has a 1947 CJ-2A for sale, but no price listed and not pics of it shared.
“For sale a 1955 Willis jeep, first year of the CJ5, all original, this is the sought after civilian jeep, not running and has mostly surface rust. Two transfer cases. This is a great restore jeep or driver. Asking $1400. I also have original 1947 jeep that I would possibly sell. I have clear North Carolina titles for both.”
UPDATE: Still Available.
(10/05/2016) Doesn’t run. It’s missing the steps.
“Willys cj-2a jeep with the L134 “Go Devil” motor. Motor is free but doesn’t run. Otherwise in good condition. 3000 obo.”
UPDATE: **SOLD** Was $2000
(11/15/2016) It’s a project.
“have a 1948 Willy’s project Jeep for sale. clean title. I started this project a while back(Years) and after a lay off and pay cut, I hate to see it sitting along side the shed. I put 1970 jeep front and rear end underneath it not sure what gear ratio. the body is all ready primed . The tool box and bed have been fiber glassed,this was done by previous owner. I have a 4.3 V6 engine that needs to be rebuilt, four speed transmission and transfer case with all the adapters needed to put it together, new motor mounts, new headers and brand new gas tank for under the drivers side seat. I also havea brand new master cylinder and clutch all in one setup with under the dash peddles. You will need a trailer to haul the jeep. I asking 2000.00 OBO (Cash only) . ”
UPDATE: **SOLD** Was $5500.
Could be a good price.
“For Sale 1948 CJ2A 4cly., 3 speed. All stock running gear. New top, tires and interior. 12 volt system. No rust. Very close to stock.’
UPDATE: Price dropped to $4400.
(07/31/2016) Looks solid.
“Straight nice hot rod jeep. Has very tight 350 chev, Aftermarket carb, intake, and hooker headers to be included, Warn Overdrive, 11″ brakes, Rancho Suspension, 35″ rubber on classic mags, Extra set of Centerline wheels. Saginaw steering, Very good Bestop, Original running gear, Has a CJ3A windshield.”
http://spokane.craigslist.org/cto/5899188679.html
Has a 2A body and a 3A windshield. It’s listed as a 1952.
“Possible trade for small excavator in working condition.
Original running gear. 4 cylinder runs good soft top and soft doors single vertical gun rack between seats. Needs a new home. ”
Lacks a drive train, among other things.
“1946 willy’s jeep project.
44 rear end
35 front end
Locking hubs
Good windshield frame”
It’s a project that’s been sitting for quite some time.
“1948 Jeep CJ2A project. Jeep hasn’t been fired up for at least 30 years. Started to redo the steering and never finished. It has a chevy 283 that has been bored with a 327 crank and a 30 30 fuelie cam. It has 11 inch brakes and 4.27 front and rear ring and pinions . The trailer can go with the Jeep if you want it. Only serious buyers please with the first with the cash will get it!”
UPDATE: Price dropped to $3800.
(11/10/2016) Runs and drives, but needs work.
“1947 jeep Willys it was a father and son project that was traded in to us. We have pics of the entire build. It does runs and drive but still needs some wiring done. Has the original 4 cylinder engine And Manuel transmission. ”
No pics provided. Given the price, you might expect to find an engine, or tranny, or even seats, but nope. Of course, the seller argues that buyers should “wake up” and that they can obtain any of those items at a local junkyard. Good luck with that.
“Selling my old Willys jeep needs some work , body is in excellent condition , no engine , no transmission, no seats, I have a new carb for it . I have had this at my uncles place , and someone has been taking parts of it , and I have made up my mind to sell it to some lucky person , all these parts can be found in a junk yard all on the cheap side , so with a few more dollars you can have a truly collectors item, so wake up people, some of the original paint can still be seen on the body. price is firm so do not try to low ball me, I have done my research . email me for more info on it .”
UPDATE: **SOLD** Was $800
Project or parts.
“Good 47 willys cj2a.. Body is pretty nice, has seats ,drivetrain is complete, ran couple years ago, also has very good windshield frame .. No title but does have tag.. Asking $1000 Maybe trade. I also have jeep snowplow setup Obo maybe trade….looking for name brand kids atv s Or dirtbike s”
UPDATE: UPDATE: **SOLD** Was $4500.
(09/20/2016) Powered by an f-head. Has an unusual locking mechanism for the PTO.
“1948 Willys CJ2A Jeep with a 1953 F4-134 willys Hurricane motor that runs awesome and has a bit more power than the original flat head. Fires right up instantly when you hit the key.
Selling because of health reasons. New carburetor, Clutch is good, New floor pans front welded in, New hat channels under the front, all welded sheet metal steel on the lower sides were rusted. the rust is all gone. Cut it all out completely and wire welded in new sheet metal. it still needs some finish sanding to be nice. it is solid now. frame is solid and has what looks like aftermarket springs for about a 2 inch lift at some point. Continue reading
Glenn spotted this one.
View all the information on eBay
“1948 Willys CJ2A project.
The original 1948 Willys body is all there except for 2 or 3 footman loops. Striped of paint. Any repairs were made with metal. Has minor dings or small dents and surface rust. Floor modified with new PTO opening to accommodate the overdrive PTO combination. See photos.
The chassis as pictured is like new. Every thing was restored or rebuilt to new condition.The frame is an OEM replacement frame. All new brake system. Rebuilt engine. All new transmission parts. Transfercase has new seals, bearing and gaskets. Warn overdrive rebuilt by Herm, Koenig model 58 dual output PTO. Rear PTO and front Rhino winch. NOS Selectro locking hubs. New tires.
Novi governor and handle, needs pulley and carburettor linkage
Includes old used parts.
Major parts needed to complete the project are; Radiator, Carburettor, Wiring Harness, Paint.
Body Number: 164174
Engine Number: LR120877A
CJ2A Tag Number: 174488
Clear Virginia title.”