It’s listed as a 1943, but looks like a 2A.

https://lakeland.craigslist.org/for/d/lakeland-1943-willys-jeep/6899503044.html

“Original motor running gear motor runs good body has some rust but not bad…4wd works great will climb over or through just about anything you put to the test…you can own a piece of history with this jeep i’m asking 2500 obo please message me if ur interested tranny”

UPDATE: **SOLD** Was $500.

Not sure how much value is here. but seems like $500 worth. No title.

“Cj2a Jeep with mods
Big project but with some good parts
Hood, windshield, gate, wheels
Has installed a ford straight 6 , no overdrive
transmission t114
Not running
cannot find title ,”

UPDATE: Still Available.

(05/26/2019) Runs and drives.

https://richmond.craigslist.org/cto/d/ashland-1947-willys-jeep-cj2a/6902657166.html

“Selling my 1947 Willys Jeep CJ2A. Don’t know too much about the history of it but I’ve owned it for a couple of years. Flathead 4 cylinder motor. I’ve done some work on it, wasn’t running when I bought it. New water pump, new copper head gasket along with a used head that I had magnafluxed at NAPA machine shop and it checked out fine with no cracks. The head it came with was cracked and caused coolant to get into the oil. It’s a 12 volt electrical system. Just installed a new carburetor because the one it came with didn’t have an accelerator pump and caused it to bog and stumble and not run like it should. Removed the fuel tank and had it cleaned and treated with sealant. Also just installed new ignition points, condenser and internal resister coil. Gauges work including speedometer, volt meter, temp gauge and oil pressure is 40 psi. The transmission shifts, hi and lo range and 4 wheel drive functions like it should. It stops but pulls a little to the right, brake shoes might need adjusted. It’s a smoker so it might need rings but it runs decent like it is. Not interested in trades”

It’s a project.

https://newjersey.craigslist.org/cto/d/boonton-1946-cj2a/6899424293.html

“1946 CJ2A #75737
Tub and frame are correct.
Motor is an L161
Planned on removing the L161 and installing a correct L134
Got started – ran out of time.
Looking to sell – $3,800.00
Located in North New Jersey”

UPDATE: **SOLD** Was $15,900

(09/01/2018) Has a 2A windshield, so not sure what model this is. Has lots of mods.

“49 Willys Jeep 4×4 Buick V6”

UPDATE: Still Available.

(02/23/2019) Doesn’t run at the moment.

https://pittsburgh.craigslist.org/cto/d/freeport-1946-willys-jeep-cj2a/6898437611.html

“Clean title in my name 4 cylinder 3 speed. Brand new 2″ lift kit (shocks and springs) included. Windshield included
No trades, no trades, no trades
It was running poorly until the starter quit. This is a Project”

UPDATE: Travis spotted this jeep. He noted that it’s been listed as an antique, which I would imagine circumvents the Craigslist fee. I suspect we’ll see more of that. One price is $1600 and another (in the text) is $1500. Body is fiberglass.

https://nh.craigslist.org/atq/d/auburn-1950-willy-jeep-project/6885742434.html

“1950 Willy Jeep Project
frame is done, have a V6 engine and trans
fiberglass body with steel fenders and windshield post
Almost all the part to put it together are there
$1,500 or best offer”

Has an f-head.

https://losangeles.craigslist.org/sfv/cto/d/canyon-country-1948-willys/6898499855.html

“48 Willy’s f134 hurricane , 3 speed t90, electric power steering, custom roll cage , beard sears 5 point harness. Lots of work done.”

UPDATE: **SOLD** Was $5500.

The passenger side of the body looks a little rough.

“1946 WILLYS JEEP CJ2A- This is the first year willys jeep became available to the general consumer after the war. Engine, Transmission, Transfer case all original. Runs drives and stops. Body and floor in good condition. Asking $5500 obo, Text only if you have any question.”

Rolling chassis.

https://spokane.craigslist.org/pts/d/osburn-willys-jeep/6898395164.html

“Late 40’s early 50’s Jeep Willy’s frame and parts. Straight frame includes all pictured. Jeep has 2 grills, fenders, and tub. Sell as one or possibly individual parts. You pick up.”

There may be some value here.

https://chico.craigslist.org/pts/d/magalia-willys/6896470339.html

“Willys jeep, tub is solid. Fenders hood grill and frame. Box of extra small willys parts to go with. 1000 for everything”

UPDATE: **SOLD** Was $1500.

It’s a project

“Hello! For sale is my 1947 Willy’s Jeep Project. Currently rolling, but not running, it was summer project but I no longer have the tools to finish it. The tub is from a 1947 Willy’s CJ2A, and it has the original seats, steering, gauges, and front axle. It has a larger Ford 8.8 Rear End to accompany the 5.3L LS Engine in the front and the 4-speed 4L60E auto transmission in the middle. Will be a great project for someone to finish!
Continue reading →

Looks pretty stock. Doesn’t indicate whether it runs or not.

https://yakima.craigslist.org/wto/d/yakima-willys-jeep/6897324546.html

“1947 Willy’s CJ2A Jeep Exceptional shape for its age. Stock, stock, stock!”

No pics provided.

https://denver.craigslist.org/cto/d/hillrose-1948-willys-cj2a/6894003253.html

“A great running Jeep that was rebuilt from frame up 16 years ago . Has a costom built metal cab by ironworks works. Extra parts, elec. Winch. Ready to go. Price is firm.”

The front end has been stretched or it’s a later model frame.

https://www.facebook.com/marketplace/item/407012553479152/

“1947 WILLYS CJ2A CLEAR TITLE GOOD SEATS DOES RUN ORIGINAL ENGINE ALL 4 WHEEL DRIVE WORKS NEEDS TLC CLEAR TITLE IN MY NAME”

UPDATE: **SOLD** Was $500.

Has a rear PTO, so there could be value here.

UPDATE: **SOLD** Was $300.

“no motor”

Price is optimistic. Doesn’t run.

https://www.facebook.com/marketplace/item/2219602994793581/

“1946 willys CJ2A All original motor spins free Minimal rust 5k obo or trade for something cool”

UPDATE: **SOLD** Was for trade.

(05/09/2019) Seller wants containers.

“Willing to trade for 2-40″ containers. Please call for more info.”