The body has had some bodywork, but is supposed to run. It has a Ford GPW block that was rebuilt in Germany.

https://www.facebook.com/marketplace/item/380736374040954

“1948 Willys CJ2A, powered by a “Go Devil” L134 4 cylinder flathead engine. 3speed T90 transmission and Dana 18 transfer case. Jeep runs and drives good, shifts through all the gears and 4wd works in high and low range. The brake shoes and wheel cylinders were recently replaced, including the brake shoes on the back of the transfer case. Complete new exhaust from the manifold back.

There is evidence the jeep has had body work during its lifetime, the body is very solid with no major rust. In my opinion the jeep has a killer look and I would run it as is. Tires all hold air, due to age and sidewall cracking I would replace them before running this any distance in the road.

According to the data tag on the side of the engine it was rebuilt at Karlsfeld Ordnance Depot outside Munich Germany in 1953. The engine runs extremely well and has the best oil pressure I have seen on a L134. The block I’m told is a late WWII block and has a Ford GPW head on it. Priced below market value at $9,500”

UPDATE: **SOLD** Was $6000.

This has a fiberglass body.

“1948 jeep fiberglass body fresh rebuilt motor. New Carburetor, radiator, starter, clutch, Alternator ( 12 volt converted ) brakes, brake lines, master cylinder. Etc.. needs to be finished needs seats done and new tires.. 6k”

Runs with newer engine, but bodybuilding needs work.

https://www.facebook.com/marketplace/item/2236008183219648

“1948 Willys CJ2A. Pros: Running and driving with a gm inline 6. Frame in good shape. Hood, Windshield, front fenders and frame all in good shape. Clean New Jersey title.

Cons: Needs new floor. You can buy a completely new tub easily and have a perfect jeep. No fuel tank, no floor, no seats.”

UPDATE: Still Available.

(06/28/2022) It runs and drives.

https://www.facebook.com/marketplace/item/1005435990139517

“Runs and drives well. Does over 50mph. The previous owner had this a long time and did many modifications. It has a Dana 44 narrow track rear axle. I believe the front is upgraded also. Saginaw steering setup. The motor is an early 70s 2.0 Ford. The floor has been patched numerous times. Either way it’s a drivable 2a with paperwork and I’m firm on the price. Original vin tag on firewall, current RI registration in my name”

UPDATE: **SOLD** Was $8750.

Not quite all original, as it has some extras. Still, a pretty stock 2A for the Northwest.

“1946 Willys. All original survivor.”

UPDATE: Still Available.

(05/08/2022) Looks solid for the price.

https://www.facebook.com/marketplace/item/517427800003775

“1948 Willys CJ2A 289 Ford V8 3 Speed T-90 Transmission Dana 18 Transfer Case Dana 25 Front, Dana 41 Rear Has been a body off repair and rebuild. Body and frame are virtually rust free. This little jeep came out of Arizona. Needs complete rewiring finished and pedals and steering set up done. Will make someone a nice little jeep when it’s completed. Clear title in hand. Contact me with any questions.”

UPDATE: **SOLD** for $3500 on eBay.

Bill shared this auction for a CJ-2A with a rear PTO and gearbox. The by-it-now price is $5000.

“Up for auction is a 1946 CJ2A Willys Jeep that is a very good Agri-Jeep restoration prospect! It has the rear implement output drive gear box, implement drive shaft assembly, and a PTO (needs rebuild). There is an original rear tow ball mount. The body is very straight including the  fenders. There is some filler in both of the side steps, drivers side front and rear fenders. Continue reading →