UPDATE:  This sold quickly.  Was listed at $7500.

Sam, from Flat Fender Willys, has done a large amount of work on this rig, including the installation of a rack and pinion that makes the steering very tight and responsive.  This also has a custom dash that tilts forward.   Sam would have painted this too, but the seller’s family wanted to keep it mis-matched because they liked the character.  If you are interested in a solid, daily driver, this is worth a look.

““1960 CJ3B – V6, 3sp, soft top, bikini top, runs great, no smoke great compression and can be used as a daily driver. Lots of fun! Must see to appreciate all that has gone into this rare Willy’s model Jeep.
2010 full custom rebuild is 90% complete. Here is the short list:

Body – 1960 CJ3B not perfect but the family likes it that way and won’t let me make it shiny.

Chassis – CJ5 chassis,

Mechanical – Buick V6, 3 speed manual, rebuilt transfer case, new clutch, clutch fork, clutch plate and bearings, rebuilt wheel hubs, bearings, new parts and lines from master cylinder to each wheel master cylinder, installed emergency brake, 3” lift with new suspension, shackles, pins, bushings, center bolts, U-joints, and shocks, starter, plugs, wires, wiper blades, new dual exhaust and thrush mufflers, custom built 18 gallon fuel tank, lines, pump and filters. New starter, one of a kind custom rack & pinion system by “Unisteer” with tilt steering column. Nice tread on all (5) 32×11.50 BFG mud and snow tires mounted and balanced on old school Outlaw I aluminum 15×8 wheels.

Electrical– New starter, electrical fuse block, gages, distributor, wiring, dash, instrument panel, speakers, electronic ignition, extra 12 volt charging outlets, emergency flashers, bulbs etc… plugs, wires.

Interior – All New, custom bulkhead, floor covering, roll bar, three point seat belts front and back, new front sliding bucket seats, new rear bench seat with head rests, new soft top windows, new custom bikini top to cover all passengers, wall to wall black carpeting, custom wall panels, new shifter boots and knobs..  Only thing left to do is a little body sanding, paint.“