UPDATE: Still Available.
(08/24/2019) The windshield has been narrowed at the top, but unclear why.
https://seattle.craigslist.org/see/cto/d/kent-cj3a-willys-offroad-jeep/7134248586.html
“1952 Willys CJ3A
This custom rig is fully equipped to take you where you want to go. Plenty of horsepower and plenty of gears. This old jeep has all of the modern touches that make it a kick in the pants to drive.
The good stuff:
Engine:
TPI Chevy 350, Tuned Port Injection, RV Camshaft, Stage 3 chip
Transmission:
Chevy NV4500 5-speed, Custom shortened output shaft, Custom adapter to mate with T18 Transfer Case,
hydraulic clutch
Transfer Case:
T18 with Warn Overdrive
Front Axle:
Dana 44, 5.38 gears, ARB air locker, Chromoly axles, Longfield 300M U-joints, Warn locking hubs
Rear Axle:
Dana 44, 5.38 gears, Detroit Locker, Warn full floater kit, Warn locking hubs
Other:
on-board air, 4-wheel disc brakes, power steering, power brakes, beadlock wheels, narrowed windsheild, two stage fuel system, Warn 8274 winch, M151 MUTT grill, stretched hood, bikini top, passenger side seat heater
The bad stuff:
one of the tires goes flat over a few days, the body is a bit rough (not rusted bad), tires are starting to crack, I did not put the matching driver seat in yet ( it does come with the jeep)”
Looks like a MUTT grill. Don’t think I’ve seen that done before. Correction MUTT front clip and windshield.
Is that a Mihandra grill? The body seems to have a “hammered finish” . I’m sure it has some stories to tell from the trail work adventures.
I just couldn’t place that grille.
Peter is correct, it’s a Mutt grill, but the windshield looks to be a 3A “vented” style, modified in several ways. The MUTT windshield shown on the link has just one stamped area all the way across. Maybe a different model had the same windshield, but I didn’t see any examples of it… http://img4.wikia.nocookie.net/__cb20110511171003/jeep/images/2/2d/M151-jeep-vietnam.jpg
Hi SteveK, I think your’e right about windshield. My guess is that the owner got tired of replacing the windshield and decided to narrow it so roll cage was wider. Given the “Hammered” finish and all. Even roll cage upright appears to be well used.