UPDATE: **SOLD** Was $7500.
“I’ve had this Jeep for several years now and she’s an absolute BEAST. The guy I got it from was selling it and his motorcycle to pay for his daughter’s wedding. I have other things I want to do as well so I’m selling some of my toys. One of my motorcycles is gone and now this. I have a clean title in hand. The beast is registered and insured.
Since I’ve had it I’ve put a couple thousand miles on it and replaced the master cylinder for the clutch and brakes. I’ve driven it on the freeway and while the odometer is obviously off, my buddy said we were doing 80-85. I actually think it does better on the freeway.
I’m going to list issue first –
-It does have a minor oil leak that I haven’t tracked down mostly because it is minor and hasn’t caused me much mess (it stays garaged) in my garage.
-You can’t be much taller than 6′ or you will be cramped. The seat is bolted back as far as it can and goes up against the rear wheel well. If you want to go further you would need to shave the wheel well.
-Something is up with the E-break. I just park in gear and have a block for in my garage because I have a 6 year old.
-The right gas tank, I can switch to it and the jeep continues to run, but won’t start off it.
-Not really a negative, but due to the engine, it does take premium.
Ok now that that’s out of the way, here are the details on the Jeep PRIOR to me getting it. Like I said above, I’ve added a couple thousand miles and replaced the master cylinder. It also has 5 matching rims and tires. Excellent tread left.
4WD
3Speed
2000lb wench
Tow bar and system set up ready to tow behind any truck or RV
2 Fuel tanks
No Top only Bimini
400HP
Too Much to list
Runs amazing and drives great!
Everything works
Ready for summer
New suspension with all Rancho
Brand New Tires
327 Vette Motor with 5K miles
NO RUST!!!
All new body and motor mounts!!
10:4 Gear Ratio front and back
Dana 44 rear end
Malory ignition
updated clutch swing petals
Saginaw steering conversion
Cadillac tilt wheel with telescope
Full cage
Selecto hubs”
There are pictures now. Looks good to me.
thanks Seth
When did the tubs drop the pioneer tool indents?
Approx #29500 according to the CJ-2A Page.
send more info.
Hi Ludy,
It looks like this one sold. I’ve updated the post.
– Dave