It’s a project.

https://spokane.craigslist.org/cto/6104133588.html

“This is a great Jeep needs finishing. Body is a fiberglass body and is the least desirable part of the Jeep although the grille and windshield are original steel. Front fenders and hood were in the process of being stretched but are not finished. Motor is a SBC 350 roller with long tube headers. This goes to a Lakewood scattershield and connects to a Borg Warner Super T-10 4-speed. Has a newly rebuilt Super Dana 18 transfer case which has had the interlock pin removed so you can shift into low without being in 4WD. Rear is an offset Dana 44 that has full float axles with wet hub kit, Power Lok posi, 4.27 gears and upgraded 11” brakes.

Front is a narrowed Dana 44 to keep with the correct track width, uses Scout Dana 44 outers, has an ARB air locker, 4.27 gears, Superwinch hubs and disk brakes. This is all on a postal Jeep frame that is boxed and has custom front and rear bumpers and rock sliders. Has Jeep YJ lift springs that are sprung over the axle. Has a power steering box installed but would need hooked up. Needs pinion angles set and spring perches to be welded. ARB needs plumbed. Seats need bolted in and the Painless wiring needs to be finished such as (front lights and gauges). Does fire up with the key and has a tilt GM column. Full roll cage. Has hydraulic clutch, brakes and hanging pedals. Also has a full soft top. Tires are 33×12.5×15. This Jeep has all the right parts and pieces to be a great rig.”