UPDATE: Price dropped to $250
(04/08/2011) This looks like a CJ-5/m-38a1 cage. You can tell because the front loop bend is pretty high, compared to low hood flatfender frontloops where the bend should start lower, and the front loop is the same width as the rear loop (thanks HOG).
“This cage came out of my 51jeep willys. It is powder coated blue with dark blue flacks and has two RCI seats. Asking 300obo. Thank for looking. Luke. call or tex but please no email. 3604023307”
http://seattle.craigslist.org/oly/pts/2325320870.html
Dave that must be out of a CJ5 as a 3B body tapers in in the front,, I have a nice roll cage that fits my 64 CJ-5 but Id have to change the front of it ,, But the rear roll bar fits the 3B ,, So Im just getting a frount crossover thats shorter than the back by a couple of inchs to fit my 3B…
Good catch. That is a straight shot from the back to the front. I was to fixated on the location of the front loop upper bend that I missed that important point.
– Dave
Looks like a nice roll bar ,,Wish I had it Id redo the front,, I like it whit the seats attached to the roll cage ,, If my roll gage comes off in a roll i want to be hooked to the cage not the jeep,,Matter of walking away from a bad roll,, I seen a photo of a Cj7 that roll 700 plus feet down a cliff & everything was destroyed exsept the roll cage & as luck would have it they had there seats attached to the cage,,, & they walked away from it ,,,Like theys drag cars when they come apart the driver is safer with the roll bars,, & its like a gage is built around them ,,,the weat point is the 3/8 hardare that holds it to the frame.. They have to give there welder a big sloppy kiss butt they are still alive to do so…