There are several important lessons I learned from web and software development:  1)  Real artists ship, meaning that sometimes you can’t have everything you planned or wanted in a project if you want to get it out the door; and 2) there’s always a 2.0 version.

With those lessons in mind, after several days of fiberglass filler and sanding, fiberglass filler and sanding, I’ve finally got a roughed out shape I can live with.  The reality is, more sanding is necessary to get the slopes on the bump smooth, but I can live with its imperfectness (like anything else is perfect).

I have a little final trimming on the hood edges.  After that, it’s time to pull it all apart, prepare the body for sanding/paint, drill the gauge holes in the dash, fix my brake line, and complete some odds and ends in preparation of permanently putting the body on the frame.  Oh yeah, and clean up the garage — it’s looking pretty messy in the pictures!

One of the issue’s I’ve put off until now has been the air cleaner.  I knew fitting an air cleaner between the hood and carb would be tight, a consequence of the tall Kenne Bell intake manifold.  However, I thought I might sneak it in there, but after finally fitting the hood onto the front clip, I discovered that even a low profile air cleaner won’t fit.  Unfortunately, the engine can’t drop much more (not that I want to drop and reweld the engine mounts for an extra 1 1/2 inches).  The only solution left (that I could think of) was to put a bump into the hood.  I REALLY didn’t want to do it.  But, I need to keep moving forward on this project, so I decided it was the most expedient solution.

Once decided, I then had to decide the type of bump.  After mulling it over, I chose to do a simple bump that follows the lines of the hood.  The first step was cutting the hole in the hood.  Next, I created a form out of a 2×4, putting a 20 degree edge, the same degree, but opposite, of the angle of the stripe on the body.  I laid two coats of fiberglass and resin and let it setup.  The good news is that the results are even and the angles correct.  The bad news is that I’m not thrilled with the results.  I’ve thought about adding some angles to the front to make the bump more interesting, but I think I’ll keep it simple and save the details for version 2 of the hood.

Here’s the hood precut

Here’s the hood with 3 sides cut.  I used a cutting wheel to do the cuts and a flat piece of steel as a guide to create a straight line.

Continue reading →

Last night i got the hood mounted, trimmed and latched. Once I determine where to mount the blocks (not sure what I'm going to make those out of yet), then it will be ready to patch, sand and paint.  

Over the past week I completed the form for the hood, applying a second coat of drywall mud to smooth the curves.  I had to create the hood because I lengthened the front clip about 4.5 inches.  Following that, I rubbed some turtle wax onto the form as a release agent.  Then, I laid 3 layers of fiberglass & resin.  Finally, I laid the hat channel I pulled from a different hood I had (which will serve two purposes — to hold the curve of the hood and provide support for the hinge).

As you can see below, the turtle wax didn't completely release well, so there will be some sanding.  Also, rather than apply the gelcoat to the surface of the form (which I figured would not release well at all), I have decided to apply it once I finish sand the hood.  Finally, I have done an initial trim on the hood and it fits well, but not perfect.   It will take some additional trimming, patching and sanding to finish this, but it should do fine for a first hood (much better than the first hood on my first jeep).

Continue reading →